auszookers.com
https://auszookers.com/forum/

Head tensioning on V6 GV question??????
https://auszookers.com/forum/viewtopic.php?f=5&t=32715		 Page 1 of 1
Author:  twitchy [ Fri May 18, 2012 5:11 pm ]
Post subject:  Head tensioning on V6 GV question??????
What is the reasoning behind the manual saying once tightened to 84Nm undo it till zero tension & then re- tension again.
I've built plenty of engines but never seen this??????????? Why for it say that??????????? :?
Author:  steak_knife [ Fri May 18, 2012 8:57 pm ]
Post subject:  Re: Head tensioning on V6 GV question??????
Don't think, just do.......Image
Author:  twitchy [ Fri May 18, 2012 10:20 pm ]
Post subject:  Re: Head tensioning on V6 GV question??????
steak_knife wrote:
Don't think, just do.......Image


Lol.... I did
Author:  scorpydude [ Sat May 19, 2012 6:30 am ]
Post subject:  Re: Head tensioning on V6 GV question??????
Maybe they are taking into account that no one gets it right the first time :-P
Author:  twitchy [ Sat May 19, 2012 12:06 pm ]
Post subject:  Re: Head tensioning on V6 GV question??????
It's all done now & both heads were done twice..... Timing chain now & a few ancillaries & we can go back in.
Author:  Scrawny [ Sat May 19, 2012 5:33 pm ]
Post subject:  Re: Head tensioning on V6 GV question??????
The Nissan CA18 I just did was the same
Author:  shandy92 [ Sun May 20, 2012 9:37 am ]
Post subject:  Re: Head tensioning on V6 GV question??????
a lot of the engine that i build as work need that kind of torque set, i guess it helps bring everything in evenly?
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/