auszookers.com
https://auszookers.com/forum/

Wiring a Jimny Rear Spotty
https://auszookers.com/forum/viewtopic.php?f=5&t=32740		 Page 1 of 1
Author:  lordviper556 [ Sun May 20, 2012 12:07 pm ]
Post subject:  Wiring a Jimny Rear Spotty
i have a spotty i got ages ago to use as a reverse/work light for the rear of my jimny. i making the pole is the easy part, just want to know how other people have run their wires for their lights.
Author:  Bugsta [ Sun May 20, 2012 1:12 pm ]
Post subject:  Re: Wiring a Jimny Rear Spotty
Basically, you will need the following...
SPDT Centre Off switch
Relay
Fuse
Suitable wire for light current
BATT (power)
Reverse wire
Earth

Can you draw a circuit that will work for you?
Author:  lordviper556 [ Sun May 20, 2012 1:19 pm ]
Post subject:  Re: Wiring a Jimny Rear Spotty
i know how to wire it i just wanna know how to get the wire out the back door to the light. should have been a bit clearer in my first post.
Author:  zukenutter [ Sun May 20, 2012 3:15 pm ]
Post subject:  Re: Wiring a Jimny Rear Spotty
Run the cable through to the hinge side of the door and behind the interior panel, feed it through the rubber boot conduit to the door, drill a hole in the door's outer skin and stick a rubber grommet in the hole.

Don't drill into your spare ;)
Author:  lordviper556 [ Sun May 20, 2012 3:23 pm ]
Post subject:  Re: Wiring a Jimny Rear Spotty
ok cool, i was hoping to avoid drilling a hole but if i have to i have to. rubber grommet and lots of silicone :lol:
Author:  zukenutter [ Sun May 20, 2012 4:30 pm ]
Post subject:  Re: Wiring a Jimny Rear Spotty
Get one of the grommets that are closed and put a single hole in it with a nail. Force the cable through the tiny hole and it shouldn't need silicone.

Image
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/