| auszookers.com https://auszookers.com/forum/ |
|
| Sierra engine bay plugs https://auszookers.com/forum/viewtopic.php?f=5&t=32827 |
Page 1 of 1 |
| Author: | BlueSuzy [ Wed May 23, 2012 1:22 pm ] |
| Post subject: | Sierra engine bay plugs |
In the process of doing 00'Baleno to Sierra wiring. Deleting all the crap that is not needed. Below is a pic of 1 black doova and 2 plugs. Black doova, Not sure what it does. Green plug, I know its a vac idle up valve thingo White plug is a gbox switch. My Gbox had 4 switches. Only need 1! Do i need these? 
|
|
| Author: | sogone [ Wed May 23, 2012 1:57 pm ] |
| Post subject: | Re: Sierra engine bay plugs |
With my conversion I lopped of the vac idle up. Gearbox plugs can be lopped off minus the reverse light. And the black doova I'm not sure of. I haven't seen one on any of my zooks. |
|
| Author: | BlueSuzy [ Wed May 23, 2012 4:34 pm ] |
| Post subject: | Re: Sierra engine bay plugs |
cool thanks. the black doova normally hangs around the coil. Its not the noise/radio suppressor. Might be some kind of resistor? Has bullet plugs. I just left the old stuff on my last conversion, But im now chasing neat wiring. |
|
| Author: | sogone [ Thu May 24, 2012 8:32 am ] |
| Post subject: | Re: Sierra engine bay plugs |
Come to think of it. The only Sierra stuff I kept were lights, 1 gearbox sensor, power to fuse box, trigger to starter. The rest went. Ran new wiring for cd player. And a new wire for the cig plug. I removed all the heater box stuff inside the cabin. |
|
| Author: | BlueSuzy [ Thu May 24, 2012 10:52 am ] |
| Post subject: | Re: Sierra engine bay plugs |
Ah ok  Just going to cut and loop the ends in tape. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|