[4x4xzook]

Hey Guys i have done many search's about this setup. So far all i have learnt is;

-rear vn commodore shocks for the front
-rear hilux/2wd shocks for the rear.

Has anyone installed this setup before? I am fairly new to suspension so any information would be greatfull!! will i need to relocate anything?? will it fit straight in???
my only disadvantage is i have no welder. However, i have access to someone who can weld!!

If anyone has the tiem to write up something small with a guide on what to do that would be great!! - doesnt need to be long, just a few steps.

Many thanks.

[SierraDan]

There was a full write up.. I can't seem to find it now though.

[4x4xzook]

Bump. Lookin to do this over the weekend.

[atari4x4]

SierraDan wrote:

There was a full write up.. I can't seem to find it now though.

yeah it's MIA, it used to be in the old tech section where you could submit stuff... there are a few of the old ones on the front page but not the commy/hiace shock one.

NFI where it is.



OP if you're just changing shocks it should just be remove/replace & measure for bumpstop extensions.