auszookers.com
https://auszookers.com/forum/

LSD rear Is this right HT NT Sierra leaf help please in bits
https://auszookers.com/forum/viewtopic.php?f=5&t=33086
Page 1 of 1

Author:  Fast50 [ Sat Jun 02, 2012 3:52 pm ]
Post subject:  LSD rear Is this right HT NT Sierra leaf help please in bits

I went to lock my rear and just found out it's LSD WTF is this from??? Any ideas on how I can make it a bit more LSD
Thought it was an open center???

Author:  shep [ Sat Jun 02, 2012 4:03 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

pics?

Author:  SierraDan [ Sat Jun 02, 2012 4:12 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

Are you looking at the LSD internal clutch packs? Or are you thinking its LSD because it's a 4 pin centre?

Author:  Fast50 [ Sat Jun 02, 2012 5:27 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

It's a four pin with all the bolts and shit. Don't look like an open center from a 60.. ???

Don't know how to put pics up?

Author:  SierraDan [ Sat Jun 02, 2012 5:49 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

Yeah I'd say it's an open centre as Sierra rears are 4pin.

Author:  Fast50 [ Sat Jun 02, 2012 6:45 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

Are they all closed up so u can't see any sun gears.. Thanks for the help

Author:  SierraDan [ Sat Jun 02, 2012 7:22 pm ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

Yeah. On the crown gear side there will be two slits for oil to get in but other than that, all closed up.

Author:  Fast50 [ Sun Jun 03, 2012 7:50 am ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

viewtopic.php?f=5&t=10012

Found it thanks mate... Now time for welding haha

Ps ur car is coming along well looks sick.. Do u still need the b pillar???

Author:  SierraDan [ Sun Jun 03, 2012 11:56 am ]
Post subject:  Re: LSD rear Is this right HT NT Sierra leaf help please in

Good stuff! Make sure to weld everything to everything!

Yeah it's coming along good thanks mate! If I feel motivated enough today I'll strip the front of the chassis to get it ready for the front to hit the ground!
Yeah inactively looking for one, I'm in no hurry yet until I get some work.

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/