auszookers.com
https://auszookers.com/forum/

g16b engine harness unknown wire
https://auszookers.com/forum/viewtopic.php?f=5&t=33587		 Page 1 of 1
Author:  Rossco [ Thu Jun 21, 2012 9:28 pm ]
Post subject:  g16b engine harness unknown wire
when deconstructing the vitara harness to the engine harness I pulled this wire out of the computer, terminal C2-19 (C2 is the larger of the two plugs). I have been through wiring diagrams and plugged everything into the engine, I still cant find where it goes. on the wiring diagrams C2-19 isn't used on the plug and there are no grey wires with a white tracer. I have the five wire AFM denso computer. Any ideas?

Image
Author:  Mitchie.1 [ Sat Jun 23, 2012 4:45 pm ]
Post subject:  Re: g16b engine harness unknown wire
No but I have the same one hanging around without a home. Would like to know.
Author:  Rossco [ Sat Jun 23, 2012 8:50 pm ]
Post subject:  Re: g16b engine harness unknown wire
I left it out of the harness. If it runs without it.. It's optional
Author:  stocker [ Sat Jun 23, 2012 10:50 pm ]
Post subject:  Re: g16b engine harness unknown wire
perhaps A/C Compressor?
Author:  Gwagensteve [ Sun Jun 24, 2012 5:21 pm ]
Post subject:  Re: g16b engine harness unknown wire
It was redundant in my G16B vitara loom, and my donor car had all Australian options (JLX with A/C)

I just removed it.

Steve.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/