is the handbrake/rear output spline the same size/interchangeable between them both!??
something I probably should know.. or have checked.. but havnt.. or have.. and cant recall.....
| auszookers.com https://auszookers.com/forum/ |
|
| switched vs non switched xfer https://auszookers.com/forum/viewtopic.php?f=5&t=33889 |
Page 1 of 1 |
| Author: | foolsp33d [ Thu Jul 05, 2012 8:21 am ] |
| Post subject: | switched vs non switched xfer |
is the handbrake/rear output spline the same size/interchangeable between them both!?? something I probably should know.. or have checked.. but havnt.. or have.. and cant recall.....
|
|
| Author: | shep [ Thu Jul 05, 2012 8:24 am ] |
| Post subject: | Re: switched vs non switched xfer |
different. |
|
| Author: | Scrawny [ Thu Jul 05, 2012 8:27 am ] |
| Post subject: | Re: switched vs non switched xfer |
Search noob! |
|
| Author: | 2stroker [ Thu Jul 05, 2012 8:56 am ] |
| Post subject: | Re: switched vs non switched xfer |
Are you sure about that shep, I have not had a non switch transfers for a very long time (they are even lower than a switched transfer) but for some reason I thought that it is only the input spline and front output spline that is different and that rear output spline is common across the all three, non switch, switch and 1300. |
|
| Author: | JrZook [ Thu Jul 05, 2012 10:08 am ] |
| Post subject: | Re: switched vs non switched xfer |
2stroker wrote: I thought that it is only the input spline and front output spline that is different and that rear output spline is common across the all three, non switch, switch and 1300. Correcto! |
|
| Author: | foolsp33d [ Thu Jul 05, 2012 10:30 am ] |
| Post subject: | Re: switched vs non switched xfer |
Scrawn wrote: Search noob!  sit n spin  Ta fellas.. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|