auszookers.com
https://auszookers.com/forum/

Nt ratio's
https://auszookers.com/forum/viewtopic.php?f=5&t=33926		 Page 1 of 1
Author:  juzzys [ Sat Jul 07, 2012 3:42 am ]
Post subject:  Nt ratio's
Does nt 1.3 have a higher ratio diff centre then nt 1 ltr?
Author:  303zuke [ Sat Jul 07, 2012 4:21 am ]
Post subject:  Re: Nt ratio's
Yes.

NT 1.3 is 3.909
1.0lt is 4.11

But they're not interchangable as both the ring and pinion set and also the whole housing are different sizes (1.0lt is smaller), but you can swap the complete axles (Drum to drum, or disc to disc).
Author:  juzzys [ Sat Jul 07, 2012 7:12 am ]
Post subject:  Re: Nt ratio's
Thanks mate! So if my 1 ltr is an 88 model and it has the wider tunnel etc, would It still be running the 1ltr axles? It's a late 88
Author:  Gwagensteve [ Sat Jul 07, 2012 7:36 am ]
Post subject:  Re: Nt ratio's
Yes

Steve.
Author:  zooky08 [ Sat Jul 07, 2012 7:44 am ]
Post subject:  Re: Nt ratio's
bit of confusion going on here. 88 is a nt 1.3 not a 1lt. it has a 1.3l engine. it willl have nt diffs with 3.9 1.3l size centers.
nt 1l has a higher ratio and are smaller but not interchangable with nt 1.3 or wt 1.3
Author:  juzzys [ Sat Jul 07, 2012 7:50 am ]
Post subject:  Re: Nt ratio's
Nar it's an 88 sj410 1ltr.. I think it's the very last of the 1ltr
Author:  shep [ Sat Jul 07, 2012 7:51 am ]
Post subject:  Re: Nt ratio's
zooky08 wrote:
bit of confusion going on here. 88 is a nt 1.3 not a 1lt. it has a 1.3l engine. it willl have nt diffs with 3.9 1.3l size centers.
nt 1l has a higher ratio and are smaller but not interchangable with nt 1.3 or wt 1.3

I know a fella that has a 1998 1.0 so a 88 is very possable
Author:  zooky08 [ Sat Jul 07, 2012 7:55 am ]
Post subject:  Re: Nt ratio's
i thought they only go to 87, sorry my bad.


shep wrote:
zooky08 wrote:
bit of confusion going on here. 88 is a nt 1.3 not a 1lt. it has a 1.3l engine. it willl have nt diffs with 3.9 1.3l size centers.
nt 1l has a higher ratio and are smaller but not interchangable with nt 1.3 or wt 1.3

I know a fella that has a 1998 1.0 so a 88 is very possable

most likely a maruti?
Author:  juzzys [ Sat Jul 07, 2012 8:06 am ]
Post subject:  Re: Nt ratio's
Is there any way of checking the ratio's?
Author:  zooky08 [ Sat Jul 07, 2012 8:09 am ]
Post subject:  Re: Nt ratio's
jack the back up so wheels are off the ground. for 4.1 ratio is 4 turns of the drive shaft to one rotation of the wheel.
Author:  sideways [ Sat Jul 07, 2012 9:08 am ]
Post subject:  Re: Nt ratio's
juzzys wrote:
Thanks mate! So if my 1 ltr is an 88 model and it has the wider tunnel etc, would It still be running the 1ltr axles? It's a late 88


Yep, the only 1l that had 1.3l sized diff centres was the WT Maruti (mid 90s onwards).

All 1ls have a 4.11:1 diff ratios. The only way it would be different is if someone had fitted LJ50 (4.88:1), LJ80 (4.556:1) or Super Carry (5.12:1) diff gears, or swapped the 1l diffs out for 1.3l ones.
Author:  juzzys [ Sat Jul 07, 2012 11:20 am ]
Post subject:  Re: Nt ratio's
Thanks fella's i'll do the old spin the shaft and check..
Author:  2stroker [ Sat Jul 07, 2012 2:04 pm ]
Post subject:  Re: Nt ratio's
Muzzy why are you asking, what are you chasing mate.
Author:  juzzys [ Sat Jul 07, 2012 2:39 pm ]
Post subject:  Re: Nt ratio's
I'm just looking at buying a set of 1.3 axles.. But the guy wants to sell them as a hole with the centres. And I always want to get the higher ratio for a better drive, as I'm running a 1.6..
Author:  Fatzook [ Sat Jul 07, 2012 2:50 pm ]
Post subject:  Re: Nt ratio's
zooky08 wrote:
i thought they only go to 87, sorry my bad.


shep wrote:
zooky08 wrote:
bit of confusion going on here. 88 is a nt 1.3 not a 1lt. it has a 1.3l engine. it willl have nt diffs with 3.9 1.3l size centers.
nt 1l has a higher ratio and are smaller but not interchangable with nt 1.3 or wt 1.3

I know a fella that has a 1998 1.0 so a 88 is very possable

most likely a maruti?



Stop confusing the poor bloke. :roll:


:thefinger:
Author:  Fatzook [ Sat Jul 07, 2012 2:51 pm ]
Post subject:  Re: Nt ratio's
juzzys wrote:
I'm just looking at buying a set of 1.3 axles.. But the guy wants to sell them as a hole with the centres. And I always want to get the higher ratio for a better drive, as I'm running a 1.6..



buy WT sierra diffs, reset the spring perches to NT/1L possitions, and enjoy.
Author:  juzzys [ Sat Jul 07, 2012 3:00 pm ]
Post subject:  Re: Nt ratio's
Haha. Yeah I'm thinking of going down that path but I want to get a roadworthy first..
Author:  2stroker [ Sun Jul 08, 2012 11:19 am ]
Post subject:  Re: Nt ratio's
If it is just to get it going I have a set of 1 litre axles here you can have.

(Then you can buy some wide track diffs off me latter ha ha)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/