| auszookers.com https://auszookers.com/forum/ |
|
| Transfer gearing https://auszookers.com/forum/viewtopic.php?f=5&t=3408 |
Page 1 of 1 |
| Author: | jamienoble [ Tue Nov 25, 2008 11:09 pm ] |
| Post subject: | Transfer gearing |
i have a stock leafy transfer case and was wonder when changing the gearing did you replace all the bearings in it or just the ones provided in the kit? if so did it make a big difference, would you suggest it?? and also the output, or input not sure which one it is but they suggest replacing one with a heavier duty one? what are the pros and cons of doing this?? cheers jamie |
|
| Author: | Mike [ Wed Nov 26, 2008 12:14 am ] |
| Post subject: | Re: Transfer gearing |
if the kit your looking at comes with bearings there should be enough to do the whole case if not you should replace the bearings because the ones in the case would be pretty old and it would be one less thing to worry about down the track |
|
| Author: | jamienoble [ Wed Nov 26, 2008 2:16 am ] |
| Post subject: | Re: Transfer gearing |
cheers mike and do you know approximately how much a full bearing kit would be and where to get them?? |
|
| Author: | Mike [ Wed Nov 26, 2008 2:23 am ] |
| Post subject: | Re: Transfer gearing |
locktup sell a transfer case rebuild kit for about $170 http://www.locktup4x4.com.au/product/88 ... e2684.aspx |
|
| Author: | TZAR [ Wed Nov 26, 2008 4:01 am ] |
| Post subject: | Re: Transfer gearing |
cbc sell a kit for about $110 |
|
| Author: | hooki [ Wed Nov 26, 2008 6:18 am ] |
| Post subject: | Re: Transfer gearing |
anyone know anything about the heavy duty output? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|