auszookers.com
https://auszookers.com/forum/

How to remove steering box (sierra)
https://auszookers.com/forum/viewtopic.php?f=5&t=3440		 Page 1 of 1
Author:  morpheus [ Sun Nov 30, 2008 2:11 am ]
Post subject:  How to remove steering box (sierra)
hiya guys. i got a steering box out of a wrecked sierra with no play in it. so thats better than my box with 2 1/2 inches of play in it.

getting it out of the wrecked sierra was a bastard, but because u tend 2 not give a stuff about anything, apart from the thing u want, its ok.

problem is. i cant disconnect the steering box arm, from the steering arm that connects to the left hand wheel.

i have removed the pin, and loosened the bolt to the top of the thread, then hit it from above. sprayed the crap out of it with rp7, but still cant get it off.

anyone got any advice on how to get it off? its the 1 thing stopping me from finishing the job. and im starting to get annoyed with it..
Author:  zooker [ Sun Nov 30, 2008 2:42 am ]
Post subject:  Re: How to remove steering box (sierra)
Go to supercheap and buy a ball-joint separator. You will have it off in 30 seconds :wink:
Author:  joeblow [ Sun Nov 30, 2008 3:14 am ]
Post subject:  Re: How to remove steering box (sierra)
Image
Author:  morpheus [ Sun Nov 30, 2008 3:18 am ]
Post subject:  Re: How to remove steering box (sierra)
ha, nice pic. sure i'll give that a go.

and if no luck. off to super cheap. i figured their would b a better way than what im doin. but im no mechanic. so wasn't sure.
Author:  Bruce [ Sun Nov 30, 2008 2:27 pm ]
Post subject:  Re: How to remove steering box (sierra)
Now Now Joe, That's not a noob pic :-)
Author:  TZAR [ Sun Nov 30, 2008 2:46 pm ]
Post subject:  Re: How to remove steering box (sierra)
hitting the side causes a shock load through the taper shaft

this causes it to drop off. But with a piarm they can be very tight. Sometimes you will need a pitman arm puller to remove it.

nobcad for those less technical
Author:  morpheus [ Sun Nov 30, 2008 9:29 pm ]
Post subject:  Re: How to remove steering box (sierra)
well it beat me. i cant get ther F*%ING thing off. so im gonna give the car 2 a mechanic. i bought a ball joint puller and lump hammer and thats not enough. its not the arm that comes directly off the steering box. its the arm that comes From that to the left wheel. thats the 1 i was trying 2 get off, and it just aint hapenin..

but thanks 4 tryin 2 help guys :-)
Author:  royce [ Sun Nov 30, 2008 9:34 pm ]
Post subject:  Re: How to remove steering box (sierra)
swing the hammer harder, like really hard like you are trying to break it

you wont hurt anything even if you miss and smack the chassis a few times :)
Author:  morpheus [ Mon Dec 01, 2008 12:24 pm ]
Post subject:  Re: How to remove steering box (sierra)
na i'v given up. when u have hit it that many times, sprayed it with WD40, left it overnight & smacked the shit out of it some more, & u got nowhere & have spent hours on it, its time 2 give up. so its going 2 the mechanic tuesday/wednesday. & hopefully when i get it back, i'll b able 2 go in a relatively straight line..
Author:  Brett [ Mon Dec 01, 2008 6:14 pm ]
Post subject:  Re: How to remove steering box (sierra)
keep using wd 40 for a few days, it won't happen over night but it will over a few if you keep soaking it.
Author:  joeblow [ Mon Dec 01, 2008 10:13 pm ]
Post subject:  Re: How to remove steering box (sierra)
and stop tapping it like a girlie-man. :wink:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/