auszookers.com
https://auszookers.com/forum/

LJ Body Measurements
https://auszookers.com/forum/viewtopic.php?f=5&t=34433		 Page 1 of 1
Author:  burls [ Tue Jul 24, 2012 2:03 pm ]
Post subject:  LJ Body Measurements
After some measurements please.

From the chassis to the body at each for mount bolt position
Author:  want33s [ Tue Jul 24, 2012 4:11 pm ]
Post subject:  Re: LJ Body Measurements
Don't do it!
Author:  burls [ Wed Jul 25, 2012 8:15 am ]
Post subject:  Re: LJ Body Measurements
Dont do what?
I just want the measurements of the gap between the chassis and the body at the 4 mount bolts. Mine is apart and I'm making new floor pieces and slider combos and I want to make sure I get the height right front to back
Author:  tanshi [ Wed Jul 25, 2012 8:29 am ]
Post subject:  Re: LJ Body Measurements
not sure of exactly what your after, but your welcome to come around and measure one of mine if you want.
Author:  burls [ Wed Jul 25, 2012 10:52 am ]
Post subject:  Re: LJ Body Measurements
will do, what time are you home today
Author:  tanshi [ Wed Jul 25, 2012 10:57 am ]
Post subject:  Re: LJ Body Measurements
im not, but aaron next door will be home around 5 i would say
Author:  want33s [ Wed Jul 25, 2012 4:37 pm ]
Post subject:  Re: LJ Body Measurements
burls wrote:
Dont do what?
I just want the measurements of the gap between the chassis and the body at the 4 mount bolts. Mine is apart and I'm making new floor pieces and slider combos and I want to make sure I get the height right front to back


Ah that's OK then... I thought for a minute you had ideas of putting an LJ body on a Sierra chassis. 8O
Author:  burls [ Wed Jul 25, 2012 5:48 pm ]
Post subject:  Re: LJ Body Measurements
Ha Ha

That would be a whole lot of work for a whole lot of nothing in return
Author:  303zuke [ Wed Jul 25, 2012 10:28 pm ]
Post subject:  Re: LJ Body Measurements
burls wrote:
Dont do what?
I just want the measurements of the gap between the chassis and the body at the 4 mount bolts.


They sit on pads of 8mm rubber sheet, is that what you mean?
Author:  burls [ Thu Jul 26, 2012 10:40 am ]
Post subject:  Re: LJ Body Measurements
Yeah thanks thats what I was after,

just wanted to make sure they were the same front to back and side to side.

added some pics of the slider/body mount
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/