[Hybrid]

Since I just commented about tech in chat I figured I should try to contribute some tech to tech.

The below link gives calculations on how to determine the necessary arc of contact for a belt on multiple pulleys. This helps when running more than 2 pulleys to one belt. I found it when trying to determine if I could run the crank, powersteer and supercharger pulleys off the same belt without slippage. Hopefully its helpful for other people.

http://www.bacharach-training.com/norm/arc.htm

[Damo]

I have split Jimbo's topic and put this in the tech section already

[Hybrid]

Ha, your way too good a moderator.