I have split Jimbo's topic and put this in the tech section already
| auszookers.com https://auszookers.com/forum/ |
|
| Pulley Belt Arc of Contact - Supercharger/Powersteer/AC etc. https://auszookers.com/forum/viewtopic.php?f=5&t=3468 |
Page 1 of 1 |
| Author: | Hybrid [ Wed Dec 03, 2008 1:23 pm ] |
| Post subject: | Pulley Belt Arc of Contact - Supercharger/Powersteer/AC etc. |
Since I just commented about tech in chat I figured I should try to contribute some tech to tech. The below link gives calculations on how to determine the necessary arc of contact for a belt on multiple pulleys. This helps when running more than 2 pulleys to one belt. I found it when trying to determine if I could run the crank, powersteer and supercharger pulleys off the same belt without slippage. Hopefully its helpful for other people. http://www.bacharach-training.com/norm/arc.htm |
|
| Author: | Damo [ Wed Dec 03, 2008 1:32 pm ] |
| Post subject: | Re: Pulley Belt Arc of Contact - Supercharger/Powersteer/AC |
I have split Jimbo's topic and put this in the tech section already
|
|
| Author: | Hybrid [ Wed Dec 03, 2008 3:09 pm ] |
| Post subject: | Re: Pulley Belt Arc of Contact - Supercharger/Powersteer/AC |
Ha, your way too good a moderator. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|