Looking under mine I don't think there would be enough room unless you drop the diff but I could well be wrong as usual
| auszookers.com https://auszookers.com/forum/ |
|
| G16B sump gasket https://auszookers.com/forum/viewtopic.php?f=5&t=34764 |
Page 1 of 1 |
| Author: | tsock0 [ Mon Aug 06, 2012 2:33 pm ] |
| Post subject: | G16B sump gasket |
hi all need a bit of info from the pros here my oil sump gasket has shat itself and its leaking way too much to keep on driving the car. my question is , is there enough room to replace the gasket just by undoing the sump or do i have to take out the engine? cheers |
|
| Author: | atari4x4 [ Mon Aug 06, 2012 4:05 pm ] |
| Post subject: | Re: G16B sump gasket |
i'm guessing the G16B is fitted to a Vitara... pretty sure you'll need to drop the front diff to get access to all the sump bolts, still easier than removing the engine. |
|
| Author: | tonyevans [ Mon Aug 06, 2012 4:20 pm ] |
| Post subject: | Re: G16B sump gasket |
Looking under mine I don't think there would be enough room unless you drop the diff but I could well be wrong as usual
|
|
| Author: | britvit [ Mon Aug 06, 2012 4:21 pm ] |
| Post subject: | Re: G16B sump gasket |
Are you sure it is the sump gasket and not the front main seal? |
|
| Author: | atari4x4 [ Mon Aug 06, 2012 4:34 pm ] |
| Post subject: | Re: G16B sump gasket |
tonyevans wrote: Looking under mine I don't think there would be enough room unless you drop the diff but I could well be wrong as usual Tony, you should get some industrial strength bug spray for that bee in your bonnet.
|
|
| Author: | tonyevans [ Mon Aug 06, 2012 4:45 pm ] |
| Post subject: | Re: G16B sump gasket |
Which one? - I was being serious - There does not LOOK to be enough room under mine but I don't KNOW. |
|
| Author: | atari4x4 [ Mon Aug 06, 2012 5:57 pm ] |
| Post subject: | Re: G16B sump gasket |
haha, i've got a few too... but i think they're wasps or hornets.  just noticed that you've started the "wrong as usual" thing since the plywood thread. it's definately a diff out job, but as britvit said it's probably the front or rear main seals. |
|
| Author: | Rhinoman [ Tue Aug 07, 2012 5:09 am ] |
| Post subject: | Re: G16B sump gasket |
Has it got a gasket? most of them just use sealant. |
|
| Author: | tonyevans [ Tue Aug 07, 2012 8:01 am ] |
| Post subject: | Re: G16B sump gasket |
The one I am about to rebuild has one - Sump Gasket that is. Buzzzzzzz...................... That one flew away long ago Atari |
|
| Author: | gell [ Sat May 04, 2013 9:28 pm ] |
| Post subject: | Re: G16B sump gasket |
Just wondering the same thing. I have a g16a fitted in a sierra with a 2" spring lift and am hoping it is possible to remove the sump and replace the gasket without all the other hassle of pulling the motor or dropping the diff. could someone clear this up for me. many thanks |
|
| Author: | want33s [ Sat May 04, 2013 10:42 pm ] |
| Post subject: | Re: G16B sump gasket |
gell wrote: Just wondering the same thing. I have a g16a fitted in a sierra with a 2" spring lift and am hoping it is possible to remove the sump and replace the gasket without all the other hassle of pulling the motor or dropping the diff. could someone clear this up for me. many thanks If the G16 has a Sierra 1.3 sump fitted you will have enough room to remove it. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|