| auszookers.com https://auszookers.com/forum/ |
|
| Sierra speedo cables https://auszookers.com/forum/viewtopic.php?f=5&t=35016 |
Page 1 of 1 |
| Author: | shep [ Fri Aug 17, 2012 6:05 am ] |
| Post subject: | Sierra speedo cables |
Is there a difference between where he cable fits into the transfer case from a 85 1.3 to a 96wt case? I have had a leak since fitting a late 1.3 transfer to my lwb, out of the hole the cable goes into, have tried a heap of different O rings and a new nt cable for no improvement in the leak. I am mostly certain that the case didn't leak when it was fitted to my 89 wt. Any suggestions? |
|
| Author: | Bruce [ Fri Aug 17, 2012 7:05 am ] |
| Post subject: | Re: Sierra speedo cables |
They should be the same shep. 84 to 96 will be the same. |
|
| Author: | shep [ Fri Aug 17, 2012 7:22 am ] |
| Post subject: | Re: Sierra speedo cables |
There must be something wrong with it then as the cable is loose in the hole even with the lock bolt done up |
|
| Author: | 303zuke [ Fri Aug 17, 2012 8:31 am ] |
| Post subject: | Re: Sierra speedo cables |
shep wrote: There must be something wrong with it then as the cable is loose in the hole even with the lock bolt done up In the hole? Huh? There is a collar on the end of the cable that screws on to a male thread on the speedo cable outlet. The only part of the speedo cable that goes into any hole is the cable itself into a square drive. Besides the O-ring on the on the outside of the Speedo Driven Gear housing (thats the large bush-thing that is retained with the lock bolt), there is alo a small oil seal on the inside of the housing for the shaft of the driven gear. It might be that that's causing your oil leak? |
|
| Author: | Matthew [ Sat Aug 18, 2012 12:52 am ] |
| Post subject: | Re: Sierra speedo cables |
Never seen the above mentioned cable set up on a wt Sierra, my three t-cases and another I helped rebuild were the same as Sheps. |
|
| Author: | 303zuke [ Thu Aug 23, 2012 1:09 am ] |
| Post subject: | Re: Sierra speedo cables |
Farrrrrk! Embarassing error. The set up I described with the collar retaining the cable on the Transfer end belongs to another model vehicle I have been working on. But the existance of the oil seal within the Speedo Driven Gear Housing is correct. Besides the obvious O-Ring on the out side, there is a seal on the inside. Tiny little bugger, but these are available from most bearing suppliers, or from Low Range Offroad (first item on the list) |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|