checked vacuum hoses & found 1 which was'nt on properly under carby on air filter side & idle now sits at 700-900rpm. thanks royce
| auszookers.com https://auszookers.com/forum/ |
|
| idle to low. https://auszookers.com/forum/viewtopic.php?f=5&t=3545 |
Page 1 of 1 |
| Author: | andrewa [ Sun Dec 14, 2008 9:27 pm ] |
| Post subject: | idle to low. |
just replaced leads & fuel filter due to zook losing power up hills & now car idles at about 200-400rpm. played with idle screw but no change. any suggestions people. i guess 800-1000rpm would be best? |
|
| Author: | royce [ Sun Dec 14, 2008 9:33 pm ] |
| Post subject: | Re: idle to low. |
does it drive properly? |
|
| Author: | andrewa [ Sun Dec 14, 2008 9:35 pm ] |
| Post subject: | Re: idle to low. |
yep. drives alright. does'nt feel like stalling. |
|
| Author: | royce [ Sun Dec 14, 2008 9:41 pm ] |
| Post subject: | Re: idle to low. |
bit strange, providing you hasvent bumped a vacuum hose off or anything there is no reason that should happen got the right screw? its the big long one that pokes up through the linkages |
|
| Author: | andrewa [ Sun Dec 14, 2008 9:51 pm ] |
| Post subject: | Re: idle to low. |
got the right screw royce. i'll double check the hoses around carby though. |
|
| Author: | andrewa [ Sun Dec 14, 2008 10:57 pm ] |
| Post subject: | Re: idle to low. |
checked vacuum hoses & found 1 which was'nt on properly under carby on air filter side & idle now sits at 700-900rpm. thanks royce
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|