i was thinking more along the lines of a plasma cutter
| auszookers.com https://auszookers.com/forum/ |
|
| removing dash https://auszookers.com/forum/viewtopic.php?f=5&t=3574 |
Page 1 of 1 |
| Author: | Mike [ Wed Dec 17, 2008 3:52 am ] |
| Post subject: | removing dash |
is there any way to remove a dash out of a hard top without removing the windscreen? Cheers Mike |
|
| Author: | lump_a_charcoal [ Wed Dec 17, 2008 8:16 am ] |
| Post subject: | Re: removing dash |
Chainsaw? |
|
| Author: | Mike [ Wed Dec 17, 2008 8:19 am ] |
| Post subject: | Re: removing dash |
i was thinking more along the lines of a plasma cutter
|
|
| Author: | steve [ Wed Dec 17, 2008 11:30 am ] |
| Post subject: | Re: removing dash |
If you need to take the windscreen out it's not that hard. Just take your time. I have done it a fair few times and as long as you don't rush it's ok, it's when you get impatient and start forcing it you'll break it. |
|
| Author: | BlueSuzy [ Wed Dec 17, 2008 12:38 pm ] |
| Post subject: | Re: removing dash |
Was it hard to put the windscreen in using limited tools? (My windscreen seals are bad..) Sori hijack* |
|
| Author: | lump_a_charcoal [ Wed Dec 17, 2008 6:26 pm ] |
| Post subject: | Re: removing dash |
All you need is some plastic clothesline rope and some tape - a couple of helpers is also good too. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|