| auszookers.com https://auszookers.com/forum/ |
|
| Jimny g13bb auto to manual conversion https://auszookers.com/forum/viewtopic.php?f=5&t=36267 |
Page 1 of 1 |
| Author: | Stevo87 [ Wed Oct 10, 2012 4:38 pm ] |
| Post subject: | Jimny g13bb auto to manual conversion |
Hi just wondering how hard would it be to convert a auto jimny to a manual. What parts would I need Has anyone done it before Parts won't be a problem as I will have a complete manual jimny that I might be buy from my insurance company. Just want to get an idea of the job. Thanks |
|
| Author: | jimny_timmy [ Wed Oct 10, 2012 7:21 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
Dibs on the auto transfer case if you do it! |
|
| Author: | KEENSY85 [ Wed Oct 10, 2012 8:49 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
U might be able to line some one up for a swap |
|
| Author: | stockman [ Wed Oct 10, 2012 9:16 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
KEENSY85 wrote: U might be able to line some one up for a swap Did you read the post? What model Jimny? |
|
| Author: | Stevo87 [ Wed Oct 10, 2012 9:21 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
It's a 2000 With a g13bb |
|
| Author: | -QIK- [ Thu Oct 11, 2012 6:09 am ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
When I was shopping around I got quoted $1000 for everything off suzi4 in Sydney. Clutch, flywheel, pressure plate, manual gearbox, computer, jack shaft, peddle box, clutch cable, wiring loom. The auto computer is different to the manual. So it had to be changed. The loom is plug and play change over. Wouldn't be that hard if you have some mechanical idea. You might need some help with lifting etc, but I was going to do it all myself. With the right tools you can do anything. Hope this helps. |
|
| Author: | Stevo87 [ Thu Oct 11, 2012 2:45 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
What loom is it. Is it the whole car loom or just engine loom |
|
| Author: | -QIK- [ Thu Oct 11, 2012 8:55 pm ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
Whole engine bay loom. As you un-plug it you plug the new one in around the engine bay. |
|
| Author: | Stevo87 [ Fri Oct 12, 2012 6:58 am ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
Ok sweet thanks for the info Also would the tail shaft from a auto be the same as a manual |
|
| Author: | tanshi [ Fri Oct 12, 2012 11:17 am ] |
| Post subject: | Re: Jimny g13bb auto to manual conversion |
no, that jack shaft is different auto to manual |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|