Found one
| auszookers.com https://auszookers.com/forum/ |
|
| jimny tc grinding https://auszookers.com/forum/viewtopic.php?f=5&t=36336 |
Page 1 of 1 |
| Author: | zooky08 [ Sat Oct 13, 2012 2:14 pm ] |
| Post subject: | jimny tc grinding |
went for a drive up a hill today then back down, once i got to the bottom i tried to change back into 2wd and it wouldnt. if wont go in 4h or 2wd, there is severe grinding noise in neautral. small wine in 4l. i drove the hole way back home in 4l. the Transfercase was fine when i left home. is my transfercase bugged? |
|
| Author: | 31zook [ Sat Oct 13, 2012 5:26 pm ] |
| Post subject: | Re: jimny tc grinding |
Like a Sierra, check the bush... |
|
| Author: | 303zuke [ Sat Oct 13, 2012 6:11 pm ] |
| Post subject: | Re: jimny tc grinding |
You might also have wind-up if there wasn't enough loose ground to allow the wheels to slip (that's not well written, but I hope you get the idea). Wind-up will cause pre-load on the selectors and prevent them from sliding out of gear. To releive the pressure, reverse the car about a metre and try to shift into 2wd. If you've driven home a distance on sealed roads in 4wd, you MIGHT have buggered your case, but if it's still driving, you might be OK. To release wind-up at home, jack up any one wheel. Then try to select 2wd. If this works, you are unlikely to have done long term damage. |
|
| Author: | zooky08 [ Sun Oct 14, 2012 6:45 am ] |
| Post subject: | Re: jimny tc grinding |
Ive tried driving in reverse, foward, flat ground, up hill, down hill, even on the bitumen. I drove 60km/h for half an hour home. That was top speed with out going over 4000rpm. |
|
| Author: | Scales [ Sun Oct 14, 2012 9:51 am ] |
| Post subject: | Re: jimny tc grinding |
Failing what the other blokes have suggested.. it really really isnt hard to drop it out and open it up to have a look. thats a last resort obviously, but youll get an indication straight away if something is rooted in there. |
|
| Author: | zooky08 [ Sun Oct 14, 2012 7:14 pm ] |
| Post subject: | Re: jimny tc grinding |
Are wt maruti transfercase gear set same ratio as wt 1.3l sierra gear set. Its time to put in a sierra case i think, but all i have is a wt maruti case and wt flanges. |
|
| Author: | Bugsta [ Mon Oct 15, 2012 8:09 am ] |
| Post subject: | Re: jimny tc grinding |
The flanges may be interchangable. |
|
| Author: | Scales [ Mon Oct 15, 2012 8:15 am ] |
| Post subject: | Re: jimny tc grinding |
when i put my sierra case in, it was piss easy finding the case but hard finding flanges..... maybe have a look for a newer WT case? since you have the flanges already. |
|
| Author: | zooky08 [ Mon Oct 15, 2012 9:49 am ] |
| Post subject: | Re: jimny tc grinding |
Found one
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|