a copy of the FSM is availble here http://www.suzukiinfo.com/vitara/
you want the SQ146, SQ420 & SQ625 one
| auszookers.com https://auszookers.com/forum/ |
|
| H25A Firing Order https://auszookers.com/forum/viewtopic.php?f=5&t=36702 |
Page 1 of 1 |
| Author: | klutched [ Sat Oct 27, 2012 10:34 pm ] |
| Post subject: | H25A Firing Order |
Hey guys, Does anyone know the firing order for the h25a? And also what torque the head bolts are? Cheers |
|
| Author: | atari4x4 [ Sat Oct 27, 2012 10:38 pm ] |
| Post subject: | Re: H25A Firing Order |
a copy of the FSM is availble here http://www.suzukiinfo.com/vitara/ you want the SQ146, SQ420 & SQ625 one
|
|
| Author: | atari4x4 [ Sat Oct 27, 2012 10:39 pm ] |
| Post subject: | Re: H25A Firing Order |
my pdf reader is being retarded & i can't extract the pages FML 
|
|
| Author: | dhula [ Sun Oct 28, 2012 11:36 pm ] |
| Post subject: | Re: H25A Firing Order |
Sorry for crappy pics, best I can do with what I've got Firing order is 1-6-5-4-3-2  5) Install cylinder head to block. After applying oil to cylinder head bolts, tighten them gradually as follows. (1)Tighten all bolts to 53 N.m (5.3 kg-m, 38.5 lb-ft) according to numerical order in figure. (2)In the same manner as in (1), tighten them to 84 N.m (8.4 kg-m, 61.0 lb-ft). (3) Loosen all bolts until tightening torque is reduced to 0 in reverse order of tightening. (4)In the same manner as in (1), tighten them to 53 N.m (5.3 kg-m, 38.5 lb-ft). (5) In the same manner as in (1) again, tighten them to specified torque. Tightening Torque (a): 105 N.m (10.5 kg-m, 76.0 lb-ft) (b): 11 N.m (1.1 kg-m, 7.5 lb-ft) 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|