so is it true did you crash outers
| auszookers.com https://auszookers.com/forum/ |
|
| Need a jap 8V TBI sierra wiring diagram URGENTLY https://auszookers.com/forum/viewtopic.php?f=5&t=3690 |
Page 1 of 1 |
| Author: | want33s [ Thu Jan 01, 2009 10:27 pm ] |
| Post subject: | Need a jap 8V TBI sierra wiring diagram URGENTLY |
I've got the manifold and TBI bolted to the 1.3 and have fitted both lift and high pressure fuel pumps. Just need to run a HP hose and sort the wiring. Can anyone send me a wiring diagram or point me to one online. I thought it would be easy to find but Outers and www.suzukiinfo.com are both down. Please help ASAP as I'm running out of holidays very quickly. Thanks Jas. |
|
| Author: | Damo [ Thu Jan 01, 2009 10:47 pm ] |
| Post subject: | Re: Need a jap 8V TBI sierra wiring diagram URGENTLY |
I thought I had something here but dont have anything for TBI. Our downloads section doesnt have anything either, will have a look when I get home tonight. What are you starting with? Stock loom? Have you got the engine sensors connected? All you should need to sort is the power and earth for the ECU really, and integrate some sensor feeds back to the stock Sierra loom. |
|
| Author: | shep [ Thu Jan 01, 2009 10:47 pm ] |
| Post subject: | Re: Need a jap 8V TBI sierra wiring diagram URGENTLY |
so is it true did you crash outers
|
|
| Author: | smileysmoke [ Thu Jan 01, 2009 11:29 pm ] |
| Post subject: | Re: Need a jap 8V TBI sierra wiring diagram URGENTLY |
still need the diagrams.. i am sure i have a copy of the suzukiinfo ones around. pm me your email addy bud |
|
| Author: | want33s [ Fri Jan 02, 2009 3:14 am ] |
| Post subject: | Re: Need a jap 8V TBI sierra wiring diagram URGENTLY |
Damo wrote: I thought I had something here but dont have anything for TBI. Our downloads section doesnt have anything either, will have a look when I get home tonight. Much appreciated.  Damo wrote: What are you starting with? Stock loom? Have you got the engine sensors connected? All you should need to sort is the power and earth for the ECU really, and integrate some sensor feeds back to the stock Sierra loom.
I imported the throttle body, manifold, water manifold, ECU and HP pump from NZ where they came as OEM equipment. I have the engine bay loom but is has been cut open and there are a few wires that have been cut. These are the problem, I am not sure where they go and don't want to risk the ECU with "trial & error". |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|