5mm is within factory tolerance. May even be more acurate than the OEM perches.
| auszookers.com https://auszookers.com/forum/ |
|
| Diff perch spacing https://auszookers.com/forum/viewtopic.php?f=5&t=36992 |
Page 1 of 1 |
| Author: | anDy86 [ Fri Nov 09, 2012 2:47 pm ] |
| Post subject: | Diff perch spacing |
Hi fellow auszookians, I have started my wt diff conversion on my LWB. While welding on the front perches with a mate we grinded off the markings I left for perch spacing. When I test fitted this they are about 5ml too wide compared to the original NT spacing. Am I going to run into any troubles with this or will it be fine? Thanks, Andrew |
|
| Author: | Fatzook [ Fri Nov 09, 2012 2:50 pm ] |
| Post subject: | Re: Diff perch spacing |
5mm is within factory tolerance. May even be more acurate than the OEM perches.
|
|
| Author: | anDy86 [ Fri Nov 09, 2012 2:57 pm ] |
| Post subject: | Re: Diff perch spacing |
Haha thanks fatzook! My welder mate loved your perches |
|
| Author: | dono1 [ Fri Nov 09, 2012 5:22 pm ] |
| Post subject: | Re: Diff perch spacing |
Same with the guy that welded mine! |
|
| Author: | Daves4wd [ Fri Nov 09, 2012 8:22 pm ] |
| Post subject: | Re: Diff perch spacing |
Good man Andy before you know it it'll be done |
|
| Author: | KEENSY85 [ Sat Nov 10, 2012 5:42 am ] |
| Post subject: | Re: Diff perch spacing |
There surprisingly a lot of work in the nt to wt conversion hey:) I I think it will be worth, it I'm in the middle of mine atm |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|