i have 1 and a quarter zooks now
i was thinking put the bottom end in with my original head then i can take my time with loom and that shit and still have a going zook
| auszookers.com https://auszookers.com/forum/ |
|
| baleno motor questions https://auszookers.com/forum/viewtopic.php?f=5&t=3756 |
Page 1 of 1 |
| Author: | Mike [ Wed Jan 07, 2009 3:48 am ] |
| Post subject: | baleno motor questions |
i know this probably sounds stupid but is it possible to use a baleno bottom end with a 1.3 head? also will a baleno motor work with a vitara ecu and vice versa? Cheers Mike |
|
| Author: | BlueSuzy [ Wed Jan 07, 2009 3:59 am ] |
| Post subject: | Re: baleno motor questions |
Baleno efi g16b could possibly work with a efi jimny g13bb head/ or g13b twincam head. But why bother fooking around. $$$$$ + aftermarket ecu and testing.... Vitara motor is dizzy. Old Baleno motor are dizzy So maybe vit ecu will run both. But both have different wire colours etc. But Baleno 97'on is coilpacks, So extra sensors to play with. So Baleno ecu only. Its amazing how many "G" series motors there are out there! |
|
| Author: | Mike [ Wed Jan 07, 2009 4:04 am ] |
| Post subject: | Re: baleno motor questions |
i mean 1.3 8 valve head i know it won't go aswell but i'm just wondering if it will actually fit/run |
|
| Author: | BlueSuzy [ Wed Jan 07, 2009 4:07 am ] |
| Post subject: | Re: baleno motor questions |
Have heard of ppl putting g16b heads (16v) on g16a motors(8valve) Have heard of ppl putting g13a heads (8v) on g16a motors(8valve) If your going g16b, May as well use the whole system. |
|
| Author: | Mike [ Wed Jan 07, 2009 4:11 am ] |
| Post subject: | Re: baleno motor questions |
it would just be a temperary thing just to get it going |
|
| Author: | BlueSuzy [ Wed Jan 07, 2009 4:14 am ] |
| Post subject: | Re: baleno motor questions |
Dont you have 2 zooks? Drive 1. G16b the other. take ur time. Otherwise your doubling the work.. Makes no sense to me... |
|
| Author: | Mike [ Wed Jan 07, 2009 4:20 am ] |
| Post subject: | Re: baleno motor questions |
i have 1 and a quarter zooks now
i was thinking put the bottom end in with my original head then i can take my time with loom and that shit and still have a going zook |
|
| Author: | Taff [ Wed Jan 07, 2009 5:17 am ] |
| Post subject: | Re: baleno motor questions |
and have to a head off three times? seems like way too much stuffing around |
|
| Author: | Damo [ Wed Jan 07, 2009 5:30 pm ] |
| Post subject: | Re: baleno motor questions |
Mike wrote: i mean 1.3 8 valve head
i know it won't go aswell but i'm just wondering if it will actually fit/run Valve cutouts in the pistons are different between 8v and 16v models. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|