| auszookers.com https://auszookers.com/forum/ |
|
| GV 4.3 R&P onto Vitara front diff center? https://auszookers.com/forum/viewtopic.php?f=5&t=3761 |
Page 1 of 1 |
| Author: | gravity_powered [ Wed Jan 07, 2009 9:55 pm ] |
| Post subject: | GV 4.3 R&P onto Vitara front diff center? |
Will the stock manual Grand Vitara 4.3:1 ring and pinion work with a front vitara diff center in a GV diff housing? I want to convert to the earlier manual hub system but keep the stock ratios. |
|
| Author: | royce [ Wed Jan 07, 2009 10:01 pm ] |
| Post subject: | Re: GV 4.3 R&P onto Vitara front diff center? |
I guess it will be like fitting an airlocker to a GV, the right hand cv wont clip into place but that isnt too much of a concern |
|
| Author: | steak_knife [ Sun Jul 12, 2009 4:02 pm ] |
| Post subject: | Re: GV 4.3 R&P onto Vitara front diff center? |
Gravity powered, did you end up doing the swap? & Royce, wouldn`t the cv pull out when the r/h wheel is cocked? I want to do the swap after frying my 4wd control module in the middle of nowere fri nite. if I don`t run the module I can`t burn it out again!!!!!! Cheers. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|