[anDy86]

Hi All,

I have run into a potential issue while doing my WT conversion on my NT sierra.
While welding the spring perches on the diff i may have moved the front right perch a little too close to the pumpkin making the perch not 100% straight/flat.
I have kept going with it and when installing my springs it has my my shackle angle not completely straight (if you are looking at the front of the car the shackle is angled a little sideways). i can upload a photo a bit later on for clarification if anyone needs it.

Will this cause any issues or will it be fine to go ahead with it?

[Scrawny]

Depends how much the angle is. You may wear bushes out quicker on that side

[31zook]

Did you fix your DS perch?