| auszookers.com https://auszookers.com/forum/ |
|
| Sierra steering shaft bush https://auszookers.com/forum/viewtopic.php?f=5&t=38001 |
Page 1 of 1 |
| Author: | pyrohamish [ Sun Dec 30, 2012 4:02 pm ] |
| Post subject: | Sierra steering shaft bush |
Where would one find a replacement bush for between the upper steering shaft and the column housing? My bottom one has become very easy to pull up inside the column. Its either replace or I lock it in place with self tappers. |
|
| Author: | Mattmorgo [ Sun Dec 30, 2012 7:14 pm ] |
| Post subject: | Re: Sierra steering shaft bush |
Pm bruce he makes em |
|
| Author: | just_cruizin [ Mon Dec 31, 2012 12:05 pm ] |
| Post subject: | Re: Sierra steering shaft bush |
This isn't the biscuit down near the steering box. I don't know why it would pull into the column, there shouldn't be any tension on the steering, the only load should be torsion when you turn. Post a pic of the offending part. |
|
| Author: | Fatzook [ Mon Dec 31, 2012 12:09 pm ] |
| Post subject: | Re: Sierra steering shaft bush |
I think he is talking about the rubber bush in the collapsable steering shaft. Its not servicable. Buy another steering shaft. |
|
| Author: | pyrohamish [ Tue Jan 01, 2013 6:11 pm ] |
| Post subject: | Re: Sierra steering shaft bush |
When your 4wding there is quite a bit of pushing and pulling going on. Fatzook has the right part. I ended up making a couple of new ones up out of a nylon boat trailer roller, it seems to work quite well. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|