| auszookers.com https://auszookers.com/forum/ |
|
| Spray on tray liner https://auszookers.com/forum/viewtopic.php?f=5&t=38253 |
Page 1 of 2 |
| Author: | KEENSY85 [ Fri Jan 11, 2013 11:42 am ] |
| Post subject: | Spray on tray liner |
DONT YELL AT ME. LOL Has any one besides pezz used spray on tray liner in there Zook? 1. How expensive was it (all I have found is a $300 kit  , ) 2.how practical was it does it crack quickly. I was thinking of using the ute tray liner on my Zook for the sheer opertunity of it being easy to maintain, I'm planning on having an air line plumed into the cab with a air gun to blow sand and crud out as well. So who knows anything about the subject |
|
| Author: | Travis [ Fri Jan 11, 2013 12:07 pm ] |
| Post subject: | Re: Spray on tray liner |
Hippo liner, good shit, I get it for $120 a kit haven't had a problem with it |
|
| Author: | KEENSY85 [ Fri Jan 11, 2013 12:53 pm ] |
| Post subject: | Re: Spray on tray liner |
How much would 1 kit do? And we're do u buy it? |
|
| Author: | Gwagensteve [ Fri Jan 11, 2013 1:41 pm ] |
| Post subject: | Re: Spray on tray liner |
There's also a south african product called "Bakkie Liner" (apparently they call ute tubs "bakkies" Seemed quite good. Don't know where you get it. I've used Herculiner in the past and found it very good, but the last batch I bought for the trolley tug was very, very old and the rubber solids that give it the grip had settled out. No amount of stirring would dig them out of the bottom of the can. The result looked pretty average when we applied it. Just a thought about some of these products - they are very coarsely finished for grip, which is great, but be careful using them anywhere you might rest a bare leg (like a trans tunnel) or need hand access to. some of it is abrasive enough to skin knuckles. Steve. |
|
| Author: | Ace [ Fri Jan 11, 2013 1:48 pm ] |
| Post subject: | Re: Spray on tray liner |
Call up some panel beaters and ask what they recommend... then you know what to google.. Rhino deck and gorilla "something" spring to mind. perhaps be creative on your search but I doubt its going to be cheap If you skin your knuckles your doing it right |
|
| Author: | KEENSY85 [ Fri Jan 11, 2013 2:26 pm ] |
| Post subject: | Re: Spray on tray liner |
Thanks for the response guys, Steve I never thought about the chance it was abrasive, I think for the torqe tunnel ill just wire brush it right back and get it looking more pretty and just use spray on deader for the tunnel area, also can u paint over tray liner? |
|
| Author: | Jackson [ Fri Jan 11, 2013 3:05 pm ] |
| Post subject: | Re: Spray on tray liner |
JrZook used body schultz, Ive been meaning to ask him where he got it. So Jr if you see this, where did you get it?. Looks neat. viewtopic.php?f=4&t=4826&start=14 |
|
| Author: | atari4x4 [ Fri Jan 11, 2013 3:09 pm ] |
| Post subject: | Re: Spray on tray liner |
^^^ any auto-paint supplier will get you body schutlz & a gun to apply it can also get it from stupidcheap (aka stone guard) |
|
| Author: | hooki [ Fri Jan 11, 2013 3:14 pm ] |
| Post subject: | Re: Spray on tray liner |
I used the hippo liner on my lj80. Very easy to apply and it wasn't too expensive, I think about $130. I'll be using the U-pol raptor bed liner for my sierra as I've heard only good things about it...you can also get a tintable version so you can match the paint colour of your car. |
|
| Author: | KEENSY85 [ Fri Jan 11, 2013 4:35 pm ] |
| Post subject: | Re: Spray on tray liner |
IV got a gun atm the hippo liner seems the go I'm hoping a one kit will do the hole floor, I'm thinking I'll just stone gaurd the underside |
|
| Author: | Travis [ Sat Jan 12, 2013 8:05 am ] |
| Post subject: | Re: Spray on tray liner |
One kit is more than enough to do the floor |
|
| Author: | Travis [ Sat Jan 12, 2013 8:28 am ] |
| Post subject: | Re: Spray on tray liner |
Also don't mix it all up at one that shit burns! And do it on a cool day otherwise you will have dramas |
|
| Author: | UBZ [ Sat Jan 12, 2013 8:35 am ] |
| Post subject: | Re: Spray on tray liner |
I've used both Hippo liner and Raptor liner . Hippo liner was cheaper , harder to get on nice and started lifting in places after about a year . I also found it was really hard to keep clean as the finished surface held the dirt and grim The Upol Rator liner is expensive , but went on really nice with a shilzt gun . Finished surface is easy to keep clean and has proven quite resistant to knocks and scratches .     I'm a firm believer in you get what you pay for and would use raptor liner again in a heartbeat. |
|
| Author: | Travis [ Sat Jan 12, 2013 8:39 am ] |
| Post subject: | Re: Spray on tray liner |
You do get what you pay for, hoe much is raptor liner? Also hippo liner takes ages to dry fully |
|
| Author: | Trypt [ Sat Jan 12, 2013 8:52 am ] |
| Post subject: | Re: Spray on tray liner |
anyone done the outside of a car with this sort of stuff? ive been thinking about it but not sure how it would look |
|
| Author: | Travis [ Sat Jan 12, 2013 9:11 am ] |
| Post subject: | Re: Spray on tray liner |
West coast customs or whatever their called did it, iona an american custom car show, did it on a Toyota ute, can't remember all the details, would be durable and you wouldn't have to worry about scratches or chips ever again |
|
| Author: | Trypt [ Sat Jan 12, 2013 9:47 am ] |
| Post subject: | Re: Spray on tray liner |
exactly what i was thinking. and i suck at spray painting so theres another benefit |
|
| Author: | Travis [ Sat Jan 12, 2013 10:45 am ] |
| Post subject: | Re: Spray on tray liner |
Spray paintings easy haha, make sure if you do paint your car with raptor liner that it has uv protection too |
|
| Author: | KEENSY85 [ Sat Jan 12, 2013 4:26 pm ] |
| Post subject: | Re: Spray on tray liner |
We're do u buy the raptor liner |
|
| Author: | Trypt [ Sat Jan 12, 2013 4:32 pm ] |
| Post subject: | Re: Spray on tray liner |
X2 
|
|
| Author: | Trypt [ Sat Jan 12, 2013 4:32 pm ] |
| Post subject: | Re: Spray on tray liner |
X2
|
|
| Author: | Travis [ Sat Jan 12, 2013 4:44 pm ] |
| Post subject: | Re: Spray on tray liner |
http://www.ebay.com.au/itm/Raptor-SPRAY ... 931wt_1057 |
|
| Author: | KEENSY85 [ Sat Jan 12, 2013 4:54 pm ] |
| Post subject: | Re: Spray on tray liner |
Travis wrote: http://www.ebay.com.au/itm/Raptor-SPRAY-BLACK-TRUCK-BED-LINER-Urethane-2K-Kit-/200877425655?pt=Motors_Automotive_Tools&hash=item2ec53a43f7#ht_2931wt_1057 Since September 11 Americans can not ship stuff like that to aus |
|
| Author: | KEENSY85 [ Sat Jan 12, 2013 5:35 pm ] |
| Post subject: | Re: Spray on tray liner |
Sorry I think I stand correcte , I just purchased some on ebay |
|
| Author: | Trypt [ Sat Jan 12, 2013 6:18 pm ] |
| Post subject: | Re: Spray on tray liner |
i would like to do it in white. the tintable stuff says add paint. what sort of paint can you use |
|
| Author: | pezz [ Sat Jan 12, 2013 6:28 pm ] |
| Post subject: | Re: Spray on tray liner |
Trypt wrote: i would like to do it in white. the tintable stuff says add paint. what sort of paint can you use The speedliner product i worked with used it own brand of tints |
|
| Author: | whincup [ Sat Jan 12, 2013 6:30 pm ] |
| Post subject: | Re: Spray on tray liner |
wow, that looks great! how much does this do for sound deadening? |
|
| Author: | Scrawny [ Sat Jan 12, 2013 7:29 pm ] |
| Post subject: | Re: Spray on tray liner |
Gwagensteve wrote: There's also a south african product called "Bakkie Liner" (apparently they call ute tubs "bakkie") A bakkie (pronounced 'buck-ee') is a ute - the whole vehicle (not just the tub) |
|
| Author: | tomtheshooter [ Sun Jan 13, 2013 8:36 am ] |
| Post subject: | Re: Spray on tray liner |
The workshop I work at does Rhino lining, they have special pigments to add to the poly urethane to change the colour. I was thining of getting my floor pan done in rhino. might cost more than buying the kit and doing it myself but i get a warranty and dont have to buy spray guns and masking sheets etc and masking everything up inside and out is very important because it doesnt come off easily. Plus it drys in 28 seconds and I've never seen one peel back or crack. |
|
| Author: | Zuzukie [ Sun Jan 13, 2013 8:47 am ] |
| Post subject: | Re: Spray on tray liner |
Theres an australian mob called hyper seal australia They recycle old tyres and rubber etc and make it into a water based acrylic paint I seen a tub of it for $130 for 4 litres www.hypersealaustralia.com.au Dunno what its like durability wise but just something that i was shown while i was lookin for something so i could have a hard wearing hose out interior |
|
| Page 1 of 2 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|