| auszookers.com https://auszookers.com/forum/ |
|
| brake set up https://auszookers.com/forum/viewtopic.php?f=5&t=38337 |
Page 1 of 1 |
| Author: | burls [ Mon Jan 14, 2013 7:30 pm ] |
| Post subject: | brake set up |
I'm trying to work out my new brake set up for my LJ The set up so far Vitara master, Sierra disc front and back, Sierra brake lines from the master to the sierra prop valve at the rear. My problem is the Vitara has a dual outlet for the front brakes and single for the rear. The Sierra has a single outlet that splits at the chassis rail manifold. Can I just change the outlet on the Vitara master to a single? |
|
| Author: | tanshi [ Mon Jan 14, 2013 7:43 pm ] |
| Post subject: | Re: brake set up |
I run a vitara master cylinder. I just plugged one of the ports |
|
| Author: | burls [ Mon Jan 14, 2013 7:49 pm ] |
| Post subject: | Re: brake set up |
Is that on your sierra or LJ |
|
| Author: | tanshi [ Mon Jan 14, 2013 7:52 pm ] |
| Post subject: | Re: brake set up |
Both and on my previous zook too |
|
| Author: | burls [ Mon Jan 14, 2013 8:08 pm ] |
| Post subject: | Re: brake set up |
Thanks I hope now this thing can get a move, the builds been pretty slow of late. |
|
| Author: | burls [ Tue Jan 15, 2013 5:53 pm ] |
| Post subject: | Re: brake set up |
Next question I have both Vitara (not vented) and Sierra front calipers I can use- are the Vitara units better or the same? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|