| auszookers.com https://auszookers.com/forum/ |
|
| transfer case cables https://auszookers.com/forum/viewtopic.php?f=5&t=3840 |
Page 1 of 1 |
| Author: | keechox [ Fri Jan 16, 2009 10:42 pm ] |
| Post subject: | transfer case cables |
ok, quick question.... is there an easy way to get the speedo drive and hand brake cable disconnected from your transfer case? (1.3 nt) i have to take it down to workshop to get a new input shaft seal fitted but cant seem to disconnect either of these cables cheers |
|
| Author: | Mike [ Fri Jan 16, 2009 11:03 pm ] |
| Post subject: | Re: transfer case cables |
i'm not sure about the handbrake cable (i just took the whole handbrake off) to take the speedo cable off just undo that bolt on the side of the case where the cable goes in and the cable should just pull out |
|
| Author: | just_cruizin [ Sat Jan 17, 2009 2:52 am ] |
| Post subject: | Re: transfer case cables |
Just take the handbrake cable off the lever and leave it attached, it's a PITA as you have to remove the drum off the spline in the vehicle otherwise. |
|
| Author: | keechox [ Sat Jan 17, 2009 10:16 pm ] |
| Post subject: | Re: transfer case cables |
thanks guys, found the speed drive bolt under a few years of mud, just ripped the handbrake cable off where it attches to the lever |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|