| auszookers.com https://auszookers.com/forum/ |
|
| cam timing https://auszookers.com/forum/viewtopic.php?f=5&t=3892 |
Page 1 of 1 |
| Author: | shep [ Thu Jan 22, 2009 4:55 pm ] |
| Post subject: | cam timing |
i am replacing my timing belt and have lent my workshop manual to some one 
the drama that i am having is with the crank lined up with tdc and the cam on the notch ie vertical, the rotor is pointing down not as i would have thought at no 1. this is how it was when i pulled it apart. whats going on? if the cam/ dizzy is 180deg out how does it still run. have i got a magic car? G13a in a sj50 help |
|
| Author: | Scrawny [ Thu Jan 22, 2009 5:28 pm ] |
| Post subject: | Re: cam timing |
Just mark the belt with a paint pen before removing, transfer marks to new belt and hey presto!! What if you rotate crank 360 degrees? Are there 2 marks on the cam pulley? If in doubt there is a downloadable manual here in the download section. |
|
| Author: | shep [ Thu Jan 22, 2009 8:15 pm ] |
| Post subject: | Re: cam timing |
uumm lets forget that i asked this question ok. really hot day and all that. why do cams spin at half crank speed anyway. silly idea. 
|
|
| Author: | Scrawny [ Thu Jan 22, 2009 8:40 pm ] |
| Post subject: | Re: cam timing |
hehehehehehe |
|
| Author: | Rockhopper [ Thu Jan 22, 2009 10:22 pm ] |
| Post subject: | Re: cam timing |
shep wrote: why do cams spin at half crank speed anyway. silly idea. That's why they are called '4 stroke' engines 
|
|
| Author: | shep [ Thu Jan 22, 2009 11:23 pm ] |
| Post subject: | Re: cam timing |
leave me alone ya mongrals 
|
|
| Author: | ball [ Fri Jan 23, 2009 2:06 am ] |
| Post subject: | Re: cam timing |
you don't have these problems with the mighty 2 stroke
|
|
| Author: | shep [ Fri Jan 23, 2009 2:11 am ] |
| Post subject: | Re: cam timing |
ball wrote: you don't have these problems with the mighty 2 stroke
thats cos they get tossed not repaired. 
|
|
| Author: | ball [ Fri Jan 23, 2009 2:16 am ] |
| Post subject: | Re: cam timing |
shep wrote: ball wrote: you don't have these problems with the mighty 2 stroke thats cos they get tossed not repaired. only because they are too tecnical for you 
|
|
| Author: | shep [ Fri Jan 23, 2009 3:13 am ] |
| Post subject: | Re: cam timing |
ball wrote: shep wrote: ball wrote: you don't have these problems with the mighty 2 stroke thats cos they get tossed not repaired. only because they are too tecnical for you i wont deny it. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|