| auszookers.com https://auszookers.com/forum/ |
|
| swift GTI twincam head bolt torque settings and sequence? https://auszookers.com/forum/viewtopic.php?f=5&t=39236 |
Page 1 of 1 |
| Author: | Benny90 [ Mon Feb 25, 2013 6:14 pm ] |
| Post subject: | swift GTI twincam head bolt torque settings and sequence? |
I'm after what the title says. Searched google and couldn't find anything I could use. Thanks a lot in advance. |
|
| Author: | Scrawny [ Mon Feb 25, 2013 6:19 pm ] |
| Post subject: | Re: swift GTI twincam head bolt torque settings and sequence |
What gasket are you using? Normally the torque and sequence is printed on the packaging |
|
| Author: | Benny90 [ Mon Feb 25, 2013 6:55 pm ] |
| Post subject: | Re: swift GTI twincam head bolt torque settings and sequence |
Yer just a normal one mate. Bought a full vrs kit but it doesn't have any info on the torque settings. |
|
| Author: | shep [ Mon Feb 25, 2013 6:58 pm ] |
| Post subject: | Re: swift GTI twincam head bolt torque settings and sequence |
I did mine a few weeks ago, might still have the specs in the shed. Will have a look shortly |
|
| Author: | shep [ Mon Feb 25, 2013 7:21 pm ] |
| Post subject: | Re: swift GTI twincam head bolt torque settings and sequence |
I can't find the gaskit instructions but had a look in my factory manual. Head bolts are 47 to 50.5 flb. Torqued up in 3 stages so 20 then 35 then 50flb. Centre 2 bolts first then alternate bolts either side of the first two and finishing with the outside bolts last. Tighten all bolts before cranking the torque wrench up to the next step Hope this makes sense, my GTI motor has had a head stud conversion so I did 4 steps and finished up at 70 flb. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|