auszookers.com
https://auszookers.com/forum/

Have a problem with 1st gear
https://auszookers.com/forum/viewtopic.php?f=5&t=39616		 Page 1 of 1
Author:  Jake terry [ Fri Mar 15, 2013 10:09 pm ]
Post subject:  Have a problem with 1st gear
I can shift in to 1st when not moving but will moving I can't shift in to first easey any Ideas what's wrong
Sorry typeo
Author:  jdk81 [ Fri Mar 15, 2013 10:23 pm ]
Post subject:  Re: Have a problem with 1st gear
Can you start it in 1st, with clutch engaged? Then drive away afterwards?
If so, I would guess the synchro is gone, have you tried rev matching and doing a clutchless shift 2nd-1st?
Author:  missmyljdaze [ Fri Mar 15, 2013 10:30 pm ]
Post subject:  Re: Have a problem with 1st gear
deleted my response since Jake edited the typo's in his question

stephen
Author:  Jake terry [ Fri Mar 15, 2013 10:34 pm ]
Post subject:  Re: Have a problem with 1st gear
No, I can't go to first from 2nd will moving
Author:  Scrawny [ Sat Mar 16, 2013 6:09 am ]
Post subject:  Re: Have a problem with 1st gear
Most vehicles won't select 1st gear easily when moving
Author:  jdk81 [ Sat Mar 16, 2013 7:20 am ]
Post subject:  Re: Have a problem with 1st gear
When you say moving, how fast are you moving?
Author:  Jake terry [ Sat Mar 16, 2013 7:33 am ]
Post subject:  Re: Have a problem with 1st gear
Slow like at a crawl its a pain will fwding
Author:  jdk81 [ Sat Mar 16, 2013 7:41 am ]
Post subject:  Re: Have a problem with 1st gear
try rev matching, remember there is a big gap between 1st and 2nd.
So you need to near double the revs it was when in 2nd (approx 1.9 times), and then apply pressure on the gear stick and it should slot in pretty easily.

Say you are at 2000 rpm in 2nd whilst rolling, you need to press the clutch in, and open the throttle, to get the engine rpm to 3800 (1.9x2000).
This should be done quickly, without losing too much speed.

EDIT: xplainy bits mor gud, wif mor stuff
Author:  Scrawny [ Sat Mar 16, 2013 7:42 am ]
Post subject:  Re: Have a problem with 1st gear
Change the oil for something decent like Penrite then if it still doesn't go in just slam it
Author:  Ace [ Sat Mar 16, 2013 7:49 am ]
Post subject:  Re: Have a problem with 1st gear
So to confirm,

You can select first when stationary.. idle revs
You have trouble going from first to second while moving - even though slowly

Is it... changing to or from 1st... or changing into 2nd?
not many cars like shifting down into 1st while in motion, if its going into 2nd that's your problem then maybe its 2nd syncro.
2nd and 3rd syncros are the ones that usually crap out in all boxes as they are the ones that are used the most. eg, how many times do you shift through these two before you get into 5th

Try "double clutching" to check while moving - put outta gear clutch in - rev the engine ( give it lots) and try forcing the lever into other gear as revs drop.
Author:  Scrawny [ Sat Mar 16, 2013 7:53 am ]
Post subject:  Re: Have a problem with 1st gear
The way I read it he's trying to down change from second to first while moving
Author:  Ace [ Sat Mar 16, 2013 8:03 am ]
Post subject:  Re: Have a problem with 1st gear
^ nothing like that.. gas clutch in and slap
Author:  atari4x4 [ Sat Mar 16, 2013 8:23 am ]
Post subject:  Re: Have a problem with 1st gear
auto FTMFW Armsup
Author:  Ace [ Sat Mar 16, 2013 8:46 am ]
Post subject:  Re: Have a problem with 1st gear
I've been trying to swap a 5 speed vit one 130ks for a 3speed auto and havn't had many takers. Wld be keen on the 4 speed but sounds like dramas.

If I have no luck the g16 5speed is going behind the g16... (my SJ g13 one in there crunches)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/