Its a terrible pic, but if you look closely, you will see two hoses entering the intake pipe between the two blue silicone joiners. There are barbed fittings welded in.
| auszookers.com https://auszookers.com/forum/ |
|
| Air flow meter https://auszookers.com/forum/viewtopic.php?f=5&t=39698 |
Page 1 of 1 |
| Author: | burls [ Tue Mar 19, 2013 8:07 pm ] |
| Post subject: | Air flow meter |
I have to modify the intake for the Vit 1.6 to shoehorn it under the LJ bonnet. Does it make any difference where I place the airflow meter? |
|
| Author: | Fatzook [ Tue Mar 19, 2013 8:08 pm ] |
| Post subject: | Re: Air flow meter |
No. Its not a tuned intake setup. Just make sure that the two hoses that are plumbed into the intake AFTER the AFM remain between the AFM and throttle body. Also, I suspect that those smaller hoses ARE tuned length, so try not to change them. |
|
| Author: | burls [ Tue Mar 19, 2013 8:24 pm ] |
| Post subject: | Re: Air flow meter |
Thanks Fat, I thought this but just wanted to make sure. I didnt rip the engine out of the Vit so I am not sure of the hoses you mean |
|
| Author: | Fatzook [ Tue Mar 19, 2013 9:35 pm ] |
| Post subject: | Re: Air flow meter |
Its a terrible pic, but if you look closely, you will see two hoses entering the intake pipe between the two blue silicone joiners. There are barbed fittings welded in.
|
|
| Author: | burls [ Tue Mar 19, 2013 9:44 pm ] |
| Post subject: | Re: Air flow meter |
I'll check tomorrow. Your intake is something like what I was thinking of doing cheers |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|