| auszookers.com https://auszookers.com/forum/ |
|
| Which way do the driveshafts go back in? https://auszookers.com/forum/viewtopic.php?f=5&t=39804 |
Page 1 of 1 |
| Author: | whincup [ Sun Mar 24, 2013 7:51 am ] |
| Post subject: | Which way do the driveshafts go back in? |
This sounds like a stupid question, even to me  but I removed both the front and rear driveshafts, and i forgot to mark which way around they came out. the spline that allows it to expand and contract, do the shafts go back in with the male end facing the transfer and the female end facing the diff, or the other way around? hope that makes sense...
|
|
| Author: | Rusho [ Sun Mar 24, 2013 8:10 am ] |
| Post subject: | Re: Which way do the driveshafts go back in? |
Slip joint towards the transfer I thought. |
|
| Author: | BlueSuzy [ Sun Mar 24, 2013 12:13 pm ] |
| Post subject: | Re: Which way do the driveshafts go back in? |
It shouldn't matter. If you want to be picky slip joint up, only to hold grease in the spline, the downfall is that it holds mud also. |
|
| Author: | Scrawny [ Sun Mar 24, 2013 12:35 pm ] |
| Post subject: | Re: Which way do the driveshafts go back in? |
Yep, doesn't matter. I usually run the slip joint end towards the diffs |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|