auszookers.com
https://auszookers.com/forum/

Roll bar, where to add braces.
https://auszookers.com/forum/viewtopic.php?f=5&t=39909		 Page 1 of 1
Author:  douglasgiersch [ Fri Mar 29, 2013 11:44 am ]
Post subject:  Roll bar, where to add braces.
Image
Took this bar of my parts car becaus i wasnt happy with my dogey homemade crap, looked good in the photos thats about it, it's roughly 3.5mm aloy it was a 6point cage but I took the rear section off due to I'm going to run a ute style soft top, my question is should i add a braces somewhere to retain abit more strength was thinking of adding a bar from the up right section in the cab back to the parts that come back at roughly 150mm above the tub. For a tie down point but a structural brace would be best. I'm sure fat zook will chime in and help here (I'm hoping anyway)
I'm guessing strongest option would be a top corner to bottom corner type deal.
Doug
Author:  ajsr [ Fri Mar 29, 2013 3:45 pm ]
Post subject:  Re: Roll bar, where to add braces.
unless the main hoop has a cross brace it is near useless
Author:  douglasgiersch [ Fri Mar 29, 2013 4:14 pm ]
Post subject:  Re: Roll bar, where to add braces.
Image
Something like that with a plate to bolt to the floor.
Author:  ajsr [ Fri Mar 29, 2013 4:21 pm ]
Post subject:  Re: Roll bar, where to add braces.
personally id do one the other way in two halves welded to the other one
form a cross. im not a fan of bolted braces but each to heir own just make sure they are rated bolts not hardware grade shit
Author:  ajsr [ Fri Mar 29, 2013 4:25 pm ]
Post subject:  Re: Roll bar, where to add braces.
this is mine
its been tested seveal times :lol:
Image
Image
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/