auszookers.com
https://auszookers.com/forum/

How to get a flange off the diff
https://auszookers.com/forum/viewtopic.php?f=5&t=39957		 Page 1 of 1
Author:  hypactiv1 [ Sun Mar 31, 2013 8:15 pm ]
Post subject:  How to get a flange off the diff
Hey guys,

I have been trying to get the flange off the diff on the car are there any tricks that people have I don't have an air compresser

Robbie
Author:  Trypt [ Sun Mar 31, 2013 8:26 pm ]
Post subject:  Re: How to get a flange off the diff
have u got the nut off?

if not just use a breaker bar.

once uve got the nut off. spray some wd40 on the splines.
tap the back of the flange, top and bottom with a hammer (soft faced if uve got one)

should come off
Author:  hypactiv1 [ Sun Mar 31, 2013 8:29 pm ]
Post subject:  Re: How to get a flange off the diff
Trypt wrote:
have u got the nut off?

if not just use a breaker bar.

once uve got the nut off. spray some wd40 on the splines.
tap the back of the flange, top and bottom with a hammer (soft faced if uve got one)

should come off


That is what I am trying to get off I have used a braker bar but it wont budge
Author:  Bruce [ Sun Mar 31, 2013 8:31 pm ]
Post subject:  Re: How to get a flange off the diff
Breaker bar and long pipe onto breaker bar.
Author:  hypactiv1 [ Sun Mar 31, 2013 8:35 pm ]
Post subject:  Re: How to get a flange off the diff
Bruce wrote:
Breaker bar and long pipe onto breaker bar.



I tried that but hard to get much leavage under the car
I will try again tomorrow
Author:  Red89 [ Sun Mar 31, 2013 9:30 pm ]
Post subject:  Re: How to get a flange off the diff
Use a piece flat bar or similar like this to stop the flange from turning.

Image

viewtopic.php?f=17&t=36468&hilit=+flange+removal
Author:  hypactiv1 [ Sun Mar 31, 2013 10:01 pm ]
Post subject:  Re: How to get a flange off the diff
is there away to do that why it is still on the car
Author:  Red89 [ Sun Mar 31, 2013 10:07 pm ]
Post subject:  Re: How to get a flange off the diff
Get a length of bar long enough so that it hits the chassis rail or the ground.
Author:  hypactiv1 [ Sun Mar 31, 2013 10:15 pm ]
Post subject:  Re: How to get a flange off the diff
thanx heaps RED 89 will do this tomorow
Author:  31zook [ Sun Mar 31, 2013 10:17 pm ]
Post subject:  Re: How to get a flange off the diff
Make sure you pop out the little indent.

As others have said, breaker bar and pipe.

If you get real desperate, soak it in WD/CRC overnight, put your breaker bar and pipe on, lock the front hubs and try to drive it off ;) make sure you drive the right direction :lol:
Author:  hypactiv1 [ Sun Mar 31, 2013 10:19 pm ]
Post subject:  Re: How to get a flange off the diff
31zook wrote:
Make sure you pop out the little indent.

As others have said, breaker bar and pipe.

If you get real desperate, soak it in WD/CRC overnight, put your breaker bar and pipe on, lock the front hubs and try to drive it off ;) make sure you drive the right direction :lol:


ehat you mean pop the little indent
Author:  rick1970 [ Sun Mar 31, 2013 10:38 pm ]
Post subject:  Re: How to get a flange off the diff
hypactiv1 wrote:
31zook wrote:
Make sure you pop out the little indent.

As others have said, breaker bar and pipe.

If you get real desperate, soak it in WD/CRC overnight, put your breaker bar and pipe on, lock the front hubs and try to drive it off ;) make sure you drive the right direction :lol:


ehat you mean pop the little indent


the outter part of the nut has a ring around it that is dented??? into a mating notch on the pinion, thus locking the nut. Clean and look, it will be quite obvious. Mark nut position before dissassembly.

Breaker bar, get a solid foothold and but your back into it........it will undo.
Author:  Daves4wd [ Sun Mar 31, 2013 10:40 pm ]
Post subject:  Re: How to get a flange off the diff
What he means is there's a two little notches on the piñon that the bolt locks to if you look at it face on you'll see em... There's two oppersit each other

Beat me to it
Author:  hypactiv1 [ Sun Mar 31, 2013 10:46 pm ]
Post subject:  Re: How to get a flange off the diff
Thanx heaps guys

that is prob the resin I could not get it off spent hours trying to get it off lol
I will look first thing in the morning thanx again
Author:  bazook [ Tue Apr 02, 2013 8:54 pm ]
Post subject:  Re: How to get a flange off the diff
try a spray by loctite called freeze this should also loosen nut and flange
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/