Not having an impact gun, I used a length of flatbar drilled 2 holes closer to one edge for the bolts then used a file between the 2 holes so that I could get the socket on.
The ones on the right.
| auszookers.com https://auszookers.com/forum/ |
|
| Sierra crankshaft pulley bolt removal https://auszookers.com/forum/viewtopic.php?f=5&t=40193 |
Page 1 of 1 |
| Author: | skelly [ Wed Apr 10, 2013 6:22 pm ] |
| Post subject: | Sierra crankshaft pulley bolt removal |
I've got a g13ba in my garage I'm pulling apart and I'm having Trouble removing the crank shaft because I can't remove the crank Pulley bolt at the front. Any tips on how to get it out? |
|
| Author: | Scrawny [ Wed Apr 10, 2013 6:27 pm ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
The outer pulley comes off by removing the 5 little bolts. Then you'll need an impact gun to undo the centre bolt. You may be able to somehow wedge a pry bar onto the flywheel and use a breaker bar on the crank nut but I don't like your chances |
|
| Author: | reeceh [ Wed Apr 10, 2013 9:45 pm ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
Possibly try and ratchet strap the engine down to a work bench and get a mate to help you. One on the flywheel as mentioned and one on the centre nut |
|
| Author: | sideways [ Wed Apr 10, 2013 10:26 pm ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
Get one of these, best $80 I ever spent. I use it for anything and everything. Don't know how I lived without it.... Well slowly, painfully and with much swearing. http://www.ebay.com.au/itm/240V-IMPACT- ... 114wt_1271 |
|
| Author: | Santos [ Wed Apr 10, 2013 11:18 pm ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
reconnect your starter, there is a diagram in the factory service manual showing how to test the starter on the bench with jumper cables.. then do this http://www.youtube.com/watch?v=Zybilegox1U explained in length http://www.youtube.com/watch?v=7G-adEVjfWI have yet to do it on a suzuki but it worked on my sisters hyundai (engine spins same way) just bump the starter. I wish i had of known this a few years back when i was pulling apart a junk g13a. i had used a long tube and breaker bar and a block of wood inside jamming the crank.. even after all that it was not easy |
|
| Author: | bogga [ Thu Apr 11, 2013 7:15 am ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
Had the same issue recently when replacing the head gasket. Used a blow torch to heat the nut then impact gun. Sure it stuffed the seal behind it but this was replaced anyway. |
|
| Author: | Blkfxx [ Thu Apr 11, 2013 7:57 am ] |
| Post subject: | Re: Sierra crankshaft pulley bolt removal |
Not having an impact gun, I used a length of flatbar drilled 2 holes closer to one edge for the bolts then used a file between the 2 holes so that I could get the socket on. The ones on the right. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|