In the process of putting in a carby kit (G13BA) new hoses and good clean.
On the throttle cabke side it looks as if there is a broken rod as marked in the pic.
Question is what is it?
Cheers
| auszookers.com https://auszookers.com/forum/ |
|
| Carby part identification https://auszookers.com/forum/viewtopic.php?f=5&t=40243 |
Page 1 of 1 |
| Author: | bogga [ Sat Apr 13, 2013 1:33 pm ] |
| Post subject: | Carby part identification |
In the process of putting in a carby kit (G13BA) new hoses and good clean. On the throttle cabke side it looks as if there is a broken rod as marked in the pic. Question is what is it? Cheers |
|
| Author: | Matthew [ Sat Apr 13, 2013 5:36 pm ] |
| Post subject: | Re: Carby part identification |
It's the choke rod. Prevents the mixture from being too rich while accelerating. |
|
| Author: | bogga [ Sat Apr 13, 2013 6:34 pm ] |
| Post subject: | Re: Carby part identification |
↑ Cheers |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|