auszookers.com
https://auszookers.com/forum/

1510 Locker in Vitara Rear Diff question?
https://auszookers.com/forum/viewtopic.php?f=5&t=40362		 Page 1 of 1
Author:  Rust [ Thu Apr 18, 2013 5:41 am ]
Post subject:  1510 Locker in Vitara Rear Diff question?
Hi All :)

I just installed locker in my rear diff ...

But I was not sure if the original thrust washer and shims to sidegears still should be in the diff?
Author:  SierraDan [ Thu Apr 18, 2013 12:56 pm ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
I've always left them in, in my sierra centres.
Author:  Built4thrashing [ Thu Apr 18, 2013 5:07 pm ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
without them there may be extra play when you accel/back off and it can cause faster wear to the internal components.
Author:  Rust [ Fri Apr 19, 2013 12:17 am ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
Thanks guys :)

I Will fit the diff in my axle and hope it works :)
Author:  sideways [ Fri Apr 19, 2013 3:30 am ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
I took them out, as per the manual. It was pretty much perfect, quiet as and you don't feel it unlocking.

That was in a 1l/LJ diff.
Author:  Rust [ Fri Apr 19, 2013 3:54 am ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
sideways wrote:
I took them out, as per the manual. It was pretty much perfect, quiet as and you don't feel it unlocking.

That was in a 1l/LJ diff.



My manual don't say anything about the shims... But it says I should place the Thrust Washer?? Is this the thin "Belleville" (Cone washer)?? Or is the Thrust Washer the flat shims??
Author:  Built4thrashing [ Fri Apr 19, 2013 5:55 pm ]
Post subject:  Re: 1510 Locker in Vitara Rear Diff question?
Just follow the instructions that came with the locker. Lockright says to keep the shims, Spartin says ditch them...
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/