| auszookers.com https://auszookers.com/forum/ |
|
| WT transfer case to jimny conversion question https://auszookers.com/forum/viewtopic.php?f=5&t=40544 |
Page 1 of 1 |
| Author: | Xtreme [ Fri Apr 26, 2013 8:04 am ] |
| Post subject: | WT transfer case to jimny conversion question |
If I put in a WT transfer case (already got it) do you have to change the vacume hubs to manual locking ones? What is the benefit of manual locking hubs to the vacume are they stronger? |
|
| Author: | 31zook [ Fri Apr 26, 2013 8:08 am ] |
| Post subject: | Re: WT transfer case to jimny conversion question |
Hey mate, you should start searching a bit. People have covered this many times. Vac hubs can be unreliable due to needing a Tcase signal, vac motors all the hoses to be intact and the hubs to be greased. Where as a manual hubs need to be greased. To fit to a Jimny front end you will need a spacer some bolts and 12 cone washers. The spacer is cause of the extra lip Jimny's have for the vac operations. Hope that answers your questions. |
|
| Author: | Xtreme [ Fri Apr 26, 2013 8:13 am ] |
| Post subject: | Re: WT transfer case to jimny conversion question |
I remembered seeing that you do this mod when you do the tcase swap just not why. That answers it for me thanks. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|