| auszookers.com https://auszookers.com/forum/ |
|
| DIY Install with Transfer Gears https://auszookers.com/forum/viewtopic.php?f=5&t=40615 |
Page 1 of 1 |
| Author: | rwt65 [ Tue Apr 30, 2013 11:11 am ] |
| Post subject: | DIY Install with Transfer Gears |
Am considering installing a set of 4.16 Lowrange Gears, how hard is it to install yourself?  Have a spare transfer that I am going to put them into so not in a rush. If I attempt it I am going to take pics on the Digital camera as I dismantle so I have reference when it goes back together. Any tips or pointers? Cheers |
|
| Author: | Zook_Fan [ Tue Apr 30, 2013 11:22 am ] |
| Post subject: | Re: DIY Install with Transfer Gears |
The gears come with full instructions. They are pretty easy to put in. First set I did took about 3 hours and that was with a lot of checking and double checking each step. |
|
| Author: | SierraDan [ Tue Apr 30, 2013 11:29 am ] |
| Post subject: | Re: DIY Install with Transfer Gears |
Remove the speedo drive before man handling the output shaft haha. |
|
| Author: | rwt65 [ Tue Apr 30, 2013 11:37 am ] |
| Post subject: | Re: DIY Install with Transfer Gears |
I got all the bits n pieces, but no instructions  Just found the instructions for the 6.5s @ Lowrange and printed them off. Should be a pretty good guide Think I might give it a go 
|
|
| Author: | masterA [ Tue Apr 30, 2013 11:42 am ] |
| Post subject: | Re: DIY Install with Transfer Gears |
You'll more than likely need a press to get the new bearing on but other people have just used a hammer and got away with it A second pair of hands is always helpful |
|
| Author: | Scales [ Tue Apr 30, 2013 2:07 pm ] |
| Post subject: | Re: DIY Install with Transfer Gears |
+1 on press. I waited until supercheap had them on special before rebuilding my case. their 6t one works fine for the job. may need a bearing puller too, depends how tricky you get with the press. jobs easy with the instructions from LROR's site, idiot proof. |
|
| Author: | Daves4wd [ Tue Apr 30, 2013 4:57 pm ] |
| Post subject: | Re: DIY Install with Transfer Gears |
Must say me and my brother inlaw knocked my rebuild out in a couple hours including dropping the case it's not hard..... Just need use brains hahaha |
|
| Author: | masterA [ Wed May 01, 2013 12:59 pm ] |
| Post subject: | Re: DIY Install with Transfer Gears |
Another couple of tools you'll need is a 3/8" 13mm socket, couple of plates of 10mm plate and a piece of pipe about 10-15cm long which will need to slide over the shaft so you can press the collar While it's all apart, make sure you tap the breather hole with a 1/4" BSP tap and put a 90* elbow for a breather 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|