| auszookers.com https://auszookers.com/forum/ |
|
| OME sierra leaf spring problem https://auszookers.com/forum/viewtopic.php?f=5&t=40704 |
Page 1 of 1 |
| Author: | zookz [ Sat May 04, 2013 10:02 pm ] |
| Post subject: | OME sierra leaf spring problem |
Hi, just installed a full set of ome leaf springs to my sierra and now its got a very bad lean. (drivers side.) I thought I got medium load 40mm but it didnt really raise it anywhere 40mm if not nothing! I have done a full ruff so ordered 2x sets of rears. Now 3 of them have a '0' marking on them and 1 with a '|'. I put the ''|'' on the passenger front side because I thought it meant minus. (hope this was right?) Was I meant to get 2 with '0' and 2 with '|'? I have removed the bottom 2 load leafs on all of them too. (3 left in all packs) The code on leafs are 1AC13. Also, is the lean mainly cause by the front? Cheers |
|
| Author: | want33s [ Sat May 04, 2013 10:39 pm ] |
| Post subject: | Re: OME sierra leaf spring problem |
zookz wrote: Also, is the lean mainly cause by the front? In my experience with RUF LWB, playing with the front springs has much more effect on lean than playing with the rears. |
|
| Author: | joeblow [ Sat May 04, 2013 10:40 pm ] |
| Post subject: | Re: OME sierra leaf spring problem |
What was your before and after bottom of rim to guard measurement? |
|
| Author: | zookz [ Sat May 04, 2013 11:24 pm ] |
| Post subject: | Re: OME sierra leaf spring problem |
joeblow wrote: What was your before and after bottom of rim to guard measurement? Not sure but what I do know is that my 35's are rubbing a lil now and didn't hardy do it before. I think this is because the shackle is squatting more that what it use to be because of the leafs being slightly longer. |
|
| Author: | gregc [ Sun May 05, 2013 6:46 am ] |
| Post subject: | Re: OME sierra leaf spring problem |
I thought OME springs were marked with a '+' on the drivers side spring pack. |
|
| Author: | KEENSY85 [ Sun May 05, 2013 7:03 am ] |
| Post subject: | Re: OME sierra leaf spring problem |
The way ome mark there springs is...0 is spot on to there spring free height any thing above is over they normally have a +,- on most of there springs. With ome u should always stand the spring upside down and measure from the ground to the spring were the perch seats .this is called free height then u put the tallest on ur right hand side ,unless the mark a and b on them then a goes to the drivers side . I would take back a pair and ask for some taller rears. Put the lower ones in the front and the new taller ones in the back , |
|
| Author: | zooky08 [ Sun May 05, 2013 8:11 am ] |
| Post subject: | Re: OME sierra leaf spring problem |
zookz wrote: I think this is because the shackle is squatting more that what it use to be because of the leafs being slightly longer. this may be your problem, how did you do your ruf setup?
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|