auszookers.com
https://auszookers.com/forum/

Vit box to hilux transfer ?
https://auszookers.com/forum/viewtopic.php?f=5&t=41033		 Page 1 of 1
Author:  Bennyzarb [ Tue May 21, 2013 9:40 pm ]
Post subject:  Vit box to hilux transfer ?
How do I adapt the shafts of a vitara manual box to a twin hilux transfer ? Is there an adapter kit ?
Author:  Fatzook [ Tue May 21, 2013 10:07 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Probably easier to get a Ring-R adaptor to a toyota 5speed, then a marlin twin transfer kit for the hilux transfers.
Author:  Bennyzarb [ Wed May 22, 2013 6:35 am ]
Post subject:  Re: Vit box to hilux transfer ?
Hmmm I have the addapter kit for the vit box to my engine I just need to get a hilux transfer case now and try put them together ha :)
Author:  want33s [ Wed May 22, 2013 9:04 am ]
Post subject:  Re: Vit box to hilux transfer ?
As Fatzook said, it'll be a lot easier to use a RingR.

G16b> Vitara bellhousing> RingR adapter> Surf W56 gearbox> Hilux transfer> Marlin adapter> 2nd Hilux transfer>

Image

There is a RingR adapter going cheap in the Getting Rid of Stuff section. Look for a post by Kerrod.
Author:  SierraDan [ Wed May 22, 2013 10:23 am ]
Post subject:  Re: Vit box to hilux transfer ?
He has a GTi motor too.
Author:  Fatzook [ Wed May 22, 2013 11:30 am ]
Post subject:  Re: Vit box to hilux transfer ?
SierraDan wrote:
He has a GTi motor too.



Easy.

Gti>lucky 13>G16B bellhousing>Ring-R>W56>hilux transfer>Marlin>Hilux transfer.
Author:  Bennyzarb [ Wed May 22, 2013 12:16 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Wow thats alot of adaptors haha
Author:  Bennyzarb [ Wed May 22, 2013 12:21 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Will that be to long for the swb sierra?
Author:  SierraDan [ Wed May 22, 2013 12:26 pm ]
Post subject:  Re: Vit box to hilux transfer ?
With the second transfer. IMO yes.
Author:  want33s [ Wed May 22, 2013 1:26 pm ]
Post subject:  Re: Vit box to hilux transfer ?
I'll get some measurements of mine from front pulley to rear output of transfer and compare it to a stocko WT tintop I have.
From memory my setup is only 75mm or so longer than stock.
Author:  Fatzook [ Wed May 22, 2013 1:28 pm ]
Post subject:  Re: Vit box to hilux transfer ?
SierraDan wrote:
With the second transfer. IMO yes.



Only because of the centres rear output though.
Author:  want33s [ Thu May 23, 2013 12:49 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Bennyzarb wrote:
Will that be to long for the swb sierra?

SierraDan wrote:
With the second transfer. IMO yes.



I just measured a stock WT tintop... From front of bellhousing to rear output flange of transfer is 1100mm
My setup with an extra transfer and two adapters is 1155mm :D :D :D


I wouldn't say it is too long for a SWB Sierra. The only drama is the lack of offset on the rear output meaning you'd have to run a Vitara or Hilux rear axle assembly.
Author:  scottiej [ Fri May 24, 2013 11:45 pm ]
Post subject:  Re: Vit box to hilux transfer ?
What about a Vitara doubler to landcruiser Tcase :wink: Richard is based in the UK though.
http://www.facebook.com/RockwattEng
Image

Image
Author:  Bennyzarb [ Mon May 27, 2013 12:30 pm ]
Post subject:  Re: Vit box to hilux transfer ?
How does this setup work?
Is it a twin transfer or?
Author:  want33s [ Mon May 27, 2013 1:29 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Bennyzarb wrote:
How does this setup work?
Is it a twin transfer or?

It replaces the Vit transfer with a single Landcruiser unit... No idea why you'd want to do that except the possibility of reduction gearing which I'm pretty sure is also available for Vit.
Author:  Bennyzarb [ Tue May 28, 2013 6:05 am ]
Post subject:  Re: Vit box to hilux transfer ?
Ahh ok hmmm what about twin vit boxes will it be to week ?
Author:  jdk81 [ Tue May 28, 2013 7:27 am ]
Post subject:  Re: Vit box to hilux transfer ?
twin vit boxes will be challenging, and vit low ratio is 1.82 from recollection (so it isnt gospel etc)
high-high = 1:1
high-low = 1.82:1
low-high = 1.82:1
low-low = 3.31
Ass loads of work for low range of 3.31
You would need to cut down the 1st vit box, and weld the aluminium, back up
make an adapter plate, and an adapter or possibly get a new spline cut on the output of the first shaft (so it will fit into the input of the 2nd vit box)
Bit like this, but more work, for less gain
http://bbs.zuwharrie.com/content/topic,46349.0.html

Search is your friend
http://auszookers.com/forum/viewtopic.php?f=37&t=37205

IMO the 4.24:1 xfer gears would be the easier option
http://www.lowrangeoffroad.com/index.php/suzuki/sidekick-tracker-x90/drivetrain/sidekick-tracker-vitara-4-24-1-rockmonster-transfer-case-gears.html
Author:  SierraDan [ Tue May 28, 2013 9:06 am ]
Post subject:  Re: Vit box to hilux transfer ?
The kicker 3 is the go.
Author:  want33s [ Tue May 28, 2013 10:20 am ]
Post subject:  Re: Vit box to hilux transfer ?
SierraDan wrote:
The kicker 3 is the go.


Would be if they were still making them. Production stopped over 2 years ago.
Author:  Fatzook [ Tue May 28, 2013 11:44 am ]
Post subject:  Re: Vit box to hilux transfer ?
want33s wrote:
SierraDan wrote:
The kicker 3 is the go.


Would be if they were still making them. Production stopped over 2 years ago.


This.

The undertaker is also dead in the water.
Author:  SierraDan [ Tue May 28, 2013 11:58 am ]
Post subject:  Re: Vit box to hilux transfer ?
Its been in the back of my mind lately. Now i know how to do it haha
Author:  Brett [ Wed May 29, 2013 6:01 pm ]
Post subject:  Re: Vit box to hilux transfer ?
What about twins to the auto? Could you do twin lux pretty easy because of it being close to the toyota auto?

On a side not I read you can get a commodore v6 to bolt up to th aw4 and toyota auto box with the rodeo 3.2 auto bellhousing
Author:  SierraDan [ Wed May 29, 2013 7:11 pm ]
Post subject:  Re: Vit box to hilux transfer ?
Does it matter whether its auto or manual?

P.S. Got a Vit transfer on the way :D
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/