| auszookers.com https://auszookers.com/forum/ |
|
| Jimny lean, bent panhard bar? https://auszookers.com/forum/viewtopic.php?f=5&t=41796 |
Page 1 of 1 |
| Author: | Sookie [ Mon Jul 08, 2013 8:11 am ] |
| Post subject: | Jimny lean, bent panhard bar? |
Just put a 2inch td lift in Put springs in right (I think)? Bigger one driver side front 2nd biggest one pasnger side 3rd pasnger rear 4th driver side rear. When doing rear I seen that my panhard rod looked bent pre bad. Jimny is leaning about a 1 inch to driver side I was think the td lift countered for the jimny lean? So can a bent panhard bar make it lean? What is the best way to go about suzuki panhard rod? Buy the Adjustable ones or get a new good non bent one and but the Relocation Bracket |
|
| Author: | monley [ Mon Jul 08, 2013 7:43 pm ] |
| Post subject: | Re: Jimny lean, bent panhard bar? |
Sway bar links aren't bent? I'd start by swapping the rear coils from left to right and go from there |
|
| Author: | Sookie [ Mon Jul 08, 2013 9:21 pm ] |
| Post subject: | Re: Jimny lean, bent panhard bar? |
Ill try that tomorrow Front is still disconnected from when I was puting them in Didn't have spring compressers |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|