[Sookie]

Just put a 2inch td lift in
Put springs in right (I think)?
Bigger one driver side front
2nd biggest one pasnger side
3rd pasnger rear
4th driver side rear.
When doing rear I seen that my panhard rod looked bent pre bad.
Jimny is leaning about a 1 inch to driver side
I was think the td lift countered for the jimny lean?
So can a bent panhard bar make it lean?
What is the best way to go about suzuki panhard rod?
Buy the Adjustable ones or get a new good non bent one and but the Relocation Bracket

[monley]

Sway bar links aren't bent?

I'd start by swapping the rear coils from left to right and go from there

[Sookie]

Ill try that tomorrow
Front is still disconnected from when I was puting them in
Didn't have spring compressers