here's the first carby question
How much would it cost to redo/recondition/rebuild/whateveryoucallit the carby?
Is it worth trying to do it myself, or pay $400 or what ever it costs to get someone like Carbtech to do it?
| auszookers.com https://auszookers.com/forum/ |
|
| Carbies :-) https://auszookers.com/forum/viewtopic.php?f=5&t=42 |
Page 1 of 1 |
| Author: | steve [ Mon Jun 19, 2006 10:59 am ] |
| Post subject: | Carbies :-) |
here's the first carby question
How much would it cost to redo/recondition/rebuild/whateveryoucallit the carby? Is it worth trying to do it myself, or pay $400 or what ever it costs to get someone like Carbtech to do it? |
|
| Author: | royce [ Mon Jun 19, 2006 12:53 pm ] |
| Post subject: | Re: Carbies :-) |
sierra carbs dont have any specific vacuum, pre load or gap settings that need special stuff to set, so unless the throttle spindles are worn and have free play or the choke chamber is shot I dont see any need to pay to get it done BUT there is a reason it costs so much to do a carby, its a lot of fiddly work and cleaning, all you are doing really is pulling it apart cleaning all the crud out and putting it back together, if you dont get it super clean or put it back together properly it will still be crappy dont always blame the carby either, poor spark, stuck dizzy weights, wrong plug gap all has an effect, mine has a bit more power and uses less fuel just from fitting a hotter thermostat, even though the choke was turning off before so should of not really made a difference |
|
| Author: | steve [ Mon Jun 19, 2006 1:26 pm ] |
| Post subject: | Re: Carbies :-) |
ok, welp, i think i need to do something... coz you keep catching up to me on the road 
|
|
| Author: | royce [ Mon Jun 19, 2006 1:58 pm ] |
| Post subject: | Re: Carbies :-) |
thats cause I have a powerhouse 
and I'm not scared of sitting full throttle at 5500rpm to catch up to people 
|
|
| Author: | Sneakyzook [ Mon Jun 19, 2006 10:31 pm ] |
| Post subject: | Re: Carbies :-) |
Hey Steve what do you think Your Carb is Doing? Is it too rich or lean? If you rev the .... out of the car and then take your foot off the throttle does it continue to speed up??? (if it does its rich) Try and work out if its running rich or lean or even OK. Might help work out if U need a rebuild or look in another area eg Ignition timing |
|
| Author: | steve [ Tue Jun 20, 2006 12:07 am ] |
| Post subject: | Re: Carbies :-) |
seems to have a lack of power sometimes, like when going up a hill on the highway. and uses a fair bit of fuel. Royces 1.3L seems to have more than mine
|
|
| Author: | royce [ Tue Jun 20, 2006 12:47 am ] |
| Post subject: | Re: Carbies :-) |
mines uses heaps of fuel, and I revvv the rinnger out of it to keep up what thermostat do you have? what temp does it run at? |
|
| Author: | steve [ Tue Jun 20, 2006 1:21 am ] |
| Post subject: | Re: Carbies :-) |
the temp gauge sits really low. dunno about the thermostat. Apparently the auto choke thing was jammed on a while ago and it was running really rough, but my cousin (gary) disconnected the choke which fixed that. I don't flog it at all, maybe that's the problem
It's not that important, but would be good to sort out eventually, would be good to reduce the amount of fuel consumption for some future long distance trips. |
|
| Author: | royce [ Tue Jun 20, 2006 1:28 am ] |
| Post subject: | Re: Carbies :-) |
reason I ask is my choke worked fine, was all set properly but after putting the proper thermostat in I find it has a bit more go on the highway and uses a little less fuel, my guage sits just under the little temp symbol now, so not quite halfway, before was about 3mm off cold |
|
| Author: | steve [ Tue Jun 20, 2006 10:54 am ] |
| Post subject: | Re: Carbies :-) |
yeah mine sits about a couple mil off cold. I didn't know you could get different thermostats! |
|
| Author: | royce [ Tue Jun 20, 2006 11:20 am ] |
| Post subject: | Re: Carbies :-) |
yeah all sorts!!!!!!!!!!!!!! get the proper 92 degree one and try, if your radiator isnt up to scratch it will overheat easier though |
|
| Author: | Westie [ Sat Jul 08, 2006 7:24 pm ] |
| Post subject: | Re: Carbies :-) |
Went and got mine done a recarb at Kawana, dave there was a cabinet maker and is self taught and he had the carb problem sorted in quick time Plumming was wrong He said that is why it was using a lot of fuel 15lt per 100k Power Boster was not working REPLACED with S/H Choke was not working Mixtures were to rich Float was to high New Needle and seat Cost $130 well worth the money she runs like a sewing machine |
|
| Author: | steve [ Sun Jul 09, 2006 9:19 pm ] |
| Post subject: | Re: Carbies :-) |
sounds like my issues hugo 
|
|
| Author: | Sneakyzook [ Tue Jul 11, 2006 12:11 am ] |
| Post subject: | Re: Carbies :-) |
We stll talking car issues? Plumming was wrong Choke was not working Mixtures were to rich Float was to high New Needle and seat Sounds like the girls i used to date..........
|
|
| Author: | steve [ Tue Jul 11, 2006 11:14 am ] |
| Post subject: | Re: Carbies :-) |
i don't think anyone is game to touch that one sneaky
|
|
| Author: | frogtwat [ Thu Sep 14, 2006 5:18 pm ] |
| Post subject: | Re: Carbies :-) |
OK steal of thread time..... SJ413 1.3 LWB carb problem engine "bogs down" just above idle... but runs fine at top end rebuilt carb w/carb kit .... redone intake manifold gasket idles more smoothly now but still have the same problem.... any ideas ? could it be the fuel pump ? |
|
| Author: | Kymbo [ Thu Sep 14, 2006 8:46 pm ] |
| Post subject: | Re: Carbies :-) |
There are several small hoses running around the carb mostly to do with pollution control & such. Often the problem you mention occurs when these become cracked or blocked. Sometimes blocking said hoses also has the desired effect. For me, carbies are a job I leave to the pros. |
|
| Author: | frogtwat [ Thu Sep 14, 2006 8:59 pm ] |
| Post subject: | Re: Carbies :-) |
yeah they are all clean .... my mate is a arb mechanic !  and its got him stuffed too !
|
|
| Author: | Kymbo [ Thu Sep 14, 2006 9:13 pm ] |
| Post subject: | Re: Carbies :-) |
Then there is always the fact that zooks are temperamental little so and so's that don't alway do what they are meant to do. I've had similar probs over the years with 1.3's and even though everything seems to be right they just don't play. Even to the point of swapping the carby over and still having the problem. There are a lot of smart people that come to this site, hopefully they will have a suggestion. |
|
| Author: | Troll [ Thu Sep 14, 2006 10:06 pm ] |
| Post subject: | Re: Carbies :-) |
my brother had a similar problem with his. our machanic cleaned out the choke line there was water and crud in there after he blew all the stuff out it rang heaps better. ask sambo exactly what was done josh |
|
| Author: | frogtwat [ Thu Sep 14, 2006 10:10 pm ] |
| Post subject: | Re: Carbies :-) |
tah dude .... SAMBO !!!! ????? |
|
| Author: | royce [ Sat Sep 16, 2006 5:04 pm ] |
| Post subject: | Re: Carbies :-) |
A bog down from idle is normally the idle mixture is to lean or the accelerator pump isnt right, did you get the ball and spring in the bottom of it right? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|