| auszookers.com https://auszookers.com/forum/ |
|
| Transfer Gears https://auszookers.com/forum/viewtopic.php?f=5&t=42166 |
Page 1 of 1 |
| Author: | damø [ Fri Jul 26, 2013 3:08 pm ] |
| Post subject: | Transfer Gears |
gday guys, im new here and search wont work on my phone, im probably doing the proverbial  im installing 4:1 gears into my transfer case, with unlocked diffs and small tyres, does anyone think its worth spending money on a transfer cradle or is this mild enough to suffice for the normal mounts? also do you need a press to remove the bearings or can you just use a puller? thanks!  im new and annoying!
|
|
| Author: | SierraDan [ Fri Jul 26, 2013 6:07 pm ] |
| Post subject: | Re: Transfer Gears |
I ran 4.16 and bent the long side mount. Reinforced with some scrap steel im still using it. Its been used with 4.16, 5.14 and 6.5. I recommend a press and puller. |
|
| Author: | damø [ Sat Jul 27, 2013 2:15 pm ] |
| Post subject: | Re: Transfer Gears |
ok thanks, so the mount wasnt replaced, just welded/reinforced? i might try running it as is, if it bends ill reinforce it. hopefully a bearing puller and some improvistation will work haha. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|