Red89 wrote:
Try Offroad_Solutions
PM that ^^^ guy
memberlist.php?mode=viewprofile&u=2987
| auszookers.com https://auszookers.com/forum/ |
|
| I need some threads cut https://auszookers.com/forum/viewtopic.php?f=5&t=42222 |
Page 1 of 1 |
| Author: | burls [ Tue Jul 30, 2013 5:31 pm ] |
| Post subject: | I need some threads cut |
I need to make up a new drag link to do this I need to get the shafts turned down a bit and threads cut and a couple of internal threads done all 18mm. Can anyone recommend a shop either near Ipswich or the airport?? |
|
| Author: | sideways [ Tue Jul 30, 2013 5:42 pm ] |
| Post subject: | Re: I need some threads cut |
Get fatzook to trim down one of his cromo steering kits! |
|
| Author: | burls [ Tue Jul 30, 2013 6:23 pm ] |
| Post subject: | Re: I need some threads cut |
It's not a standard drag link and it is already chromo |
|
| Author: | Red89 [ Tue Jul 30, 2013 6:52 pm ] |
| Post subject: | Re: I need some threads cut |
Try Offroad_Solutions |
|
| Author: | burls [ Tue Jul 30, 2013 8:18 pm ] |
| Post subject: | Re: I need some threads cut |
Guys I don't want to buy anything. I want someone to machine some threads for me |
|
| Author: | just_cruizin [ Tue Jul 30, 2013 8:24 pm ] |
| Post subject: | Re: I need some threads cut |
I know someone at archerfield that could do it |
|
| Author: | atari4x4 [ Tue Jul 30, 2013 8:34 pm ] |
| Post subject: | Re: I need some threads cut |
Red89 wrote: Try Offroad_Solutions PM that ^^^ guy memberlist.php?mode=viewprofile&u=2987
|
|
| Author: | Red89 [ Tue Jul 30, 2013 9:07 pm ] |
| Post subject: | Re: I need some threads cut |
atari4x4 wrote: Glad someone knows what theyre doing 
|
|
| Author: | atari4x4 [ Tue Jul 30, 2013 9:08 pm ] |
| Post subject: | Re: I need some threads cut |
Red89 wrote: atari4x4 wrote: Glad someone knows what theyre doing 
|
|
| Author: | burls [ Wed Jul 31, 2013 4:26 am ] |
| Post subject: | Re: I need some threads cut |
ha ha I didnt realise you were referring to an AZ, I googled it and came up with some mob in the states |
|
| Author: | burls [ Wed Jul 31, 2013 1:36 pm ] |
| Post subject: | Re: I need some threads cut |
Just cruzin Who at Archerfield, thats a bit closer for me |
|
| Author: | droverdave [ Wed Jul 31, 2013 2:17 pm ] |
| Post subject: | Re: I need some threads cut |
What about Hardy Spicer at eagle farm? They are primarily a drive shaft mob, but last time i was there they had a decent machine shop. If they cant do the work, they would prolly be able to point you in the direction of someone close who can help. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|