This might help you
| auszookers.com https://auszookers.com/forum/ |
|
| G16a with auto kickdown cable https://auszookers.com/forum/viewtopic.php?f=5&t=42491 |
Page 1 of 1 |
| Author: | Suzi_shawn [ Fri Aug 16, 2013 8:40 am ] |
| Post subject: | G16a with auto kickdown cable |
Hey guys i have just bought a g16a with auto mated to it its going into a sierra just wondering were the kickdown cable hooks up? Is it to the carbie or the acc pedal? Or somewere else does anyone have any pics of the motor end of the cable |
|
| Author: | jono165 [ Fri Aug 16, 2013 2:40 pm ] |
| Post subject: | Re: G16a with auto kickdown cable |
In a vitara the cable goes from the transmission to a little pulley box thing on the drivers side guard and then out of that to where the accelerator cable connects on the carby. It is possible to run the cable from the transmission to the accelerator pedal instead. If you look up the trolley tug build on here im pretty sure it was done this way as it used a baleno motor, I'm pretty sure you can drill out the end of the cable and put a bolt through it. |
|
| Author: | Suzi_shawn [ Fri Aug 16, 2013 3:49 pm ] |
| Post subject: | Re: G16a with auto kickdown cable |
Hopefully steve or someone who has done it will chuck up some pics |
|
| Author: | Goldnomad [ Sat Aug 17, 2013 6:53 am ] |
| Post subject: | Re: G16a with auto kickdown cable |
This might help you
|
|
| Author: | Scrawny [ Sat Aug 17, 2013 6:59 am ] |
| Post subject: | Re: G16a with auto kickdown cable |
I've got an unused pulley doobie in my car still, never took it out when the auto came out |
|
| Author: | Gwagensteve [ Sat Aug 17, 2013 7:47 am ] |
| Post subject: | Re: G16a with auto kickdown cable |
I'd use the relay doovalacky if your using a carby engine and auto. That's not feasible for a EFI/ trimatic swap. Steve. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|