Ahh....righty. Cheers for that. I did read something to that effect after I posted this. Off to do some more shopping then
| auszookers.com https://auszookers.com/forum/ |
|
| Baleno injection manifold on to Vitara engine https://auszookers.com/forum/viewtopic.php?f=5&t=42676 |
Page 1 of 1 |
| Author: | Dieselsuzi [ Tue Aug 27, 2013 9:12 pm ] |
| Post subject: | Baleno injection manifold on to Vitara engine |
Probably a bit of a noob question, but is this a straight swap? I'm looking for a neater finish to a conversion for a sierra |
|
| Author: | jono165 [ Tue Aug 27, 2013 9:48 pm ] |
| Post subject: | Re: Baleno injection manifold on to Vitara engine |
I think a jimny manifold is the best option, I believe it still has the thermostat at the front like a vitara motor. If you use a baleno manifold they run a different thermostat housing on the back of the head. |
|
| Author: | Dieselsuzi [ Tue Aug 27, 2013 10:06 pm ] |
| Post subject: | Re: Baleno injection manifold on to Vitara engine |
Ahh....righty. Cheers for that. I did read something to that effect after I posted this. Off to do some more shopping then
|
|
| Author: | Gwagensteve [ Wed Aug 28, 2013 8:25 am ] |
| Post subject: | Re: Baleno injection manifold on to Vitara engine |
I reckon that's going to be a pain. There's going to be little or no commonality on sensors between the two manifolds- it's likely going to be quite a lash up to get it to work- they each run completely different computers. I understand the desire to loose the crossover pipe, but I think the hassle might not make it worth it. I have looked at reversing the vitara plenum, but there no room for the afm if you do that. I reckon if you want a baleno manifold, and a super neat engine bay then you need the baleno loom and ecu, with coil packs. Steve. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|